Shandong Jining fiberglass grid distributor 30KN fiberglass geogrid

Description :

　　Construction method:

　　At present, there are two commonly used types of fiberglass geogrids: those with self-adhesive and those without self-adhesive. Those with self-adhesive can be directly laid on a flat base, while those without self-adhesive are usually fixed with nails.

　　Construction method of self-adhesive fiberglass grating

　　1. Preparation work:

　　Complete all joint filling, pit filling, foundation reinforcement, and laying of leveling layers.

　　2. Road table condition

　　The road surface must be clean, dust-free, dry, and have a temperature between 5 degrees Celsius and 60 degrees Celsius.

　　3. Product Preparation

　　Self adhesive fiberglass geogrids should not be stored in dry environments on construction sites to maintain their stickiness.

　　Precautions

　　(1) When in contact with self-adhesive fiberglass grilles, workers must wear gloves.

　　(2) When the self-adhesive fiberglass grid is used to lay road signs and obstacles, the geogrid that obstructs this position must be cut off with a knife.

　　(3) When laying self-adhesive fiberglass grating, pleats are not allowed, so sufficient tension must be applied during the laying process.

　　(4) Overlap the end overlapping part by 75-150 millimeters, ensuring that the overlapping part follows the laying direction.

　　(5) Overlap the overlapping parts on both sides by 25-50 millimeters.

　　(6) After laying and rolling, only construction vehicles or emergency vehicles are allowed to walk on it, but it should be ensured that the geogrid is not damaged by the turning or braking of vehicles.

　　(7) The pavement of the geogrid that has been laid must be paved with asphalt mixture on the same day, and the thickness of the surface asphalt layer should be greater than 40 millimeters.

AfterSalesService :

• Fiberglass grid distributor