12cm wide adhesive tape and 15cm asphalt sealing tape manufacturer

Description :

　　Construction technology of adhesive tape

　　1. The specifications of the adhesive tape used are usually 8cm, 5cm, and 3cm, depending on the width of the road surface crack (joint).

　　2. Use an electric brush and hair dryer to clean the cracks (joints) that choose to use adhesive tape. The surface of the cracks must be flat (cracks with a width greater than 5mm must be filled with polymer sealant first), without large protrusions, depressions, looseness, gravel or oil marks, grease and other dirt; If there are large pits, they must be filled.

　　3. Peel off the isolation paper on the back of the adhesive tape, with the non adhesive side facing upwards, and use the crack (joint) as the center line to evenly apply the adhesive tape to the road surface. In the northeast and northwest regions, when the temperature is below 15 ℃, glue should be applied first or a mixture of diesel and gasoline (diesel to gasoline ratio 1:1) should be applied to both sides of the crack before pasting.

　　4. In case of irregular cracks (joints), a paper cutter or scissors can be used to cut the adhesive tape and follow the direction of the cracks (joints) to paste. But at the junction of the adhesive tape and the adhesive tape, an overlap of 80-100mm should be formed.

　　5. Use a roller to press the seam tape firmly onto the ground, ensuring that the seam tape is integrated with the road surface without any bubbles or wrinkles.

　　6. After the construction of the joint tape is completed, try to protect the finished road surface as much as possible to avoid pollution and damage to the surface of the joint tape.

　　7. It can open up transportation.

AfterSalesService :

• 12cm wide adhesive tape