2ZBJ24/10 Coal Mine Pneumatic Grouting Pump for Leak Sealing and Hole Sealing Underground Pneumatic Grouting Pump

Description :

　　Underground pneumatic grouting pump 2ZBJ24/10 coal mine pneumatic grouting pump for leak sealing and hole sealing

　　Which one has itPneumatic grouting pump for underground useAs for the demand, Hongyi Technology has a high enthusiasm for supplying you, with sufficient preparation and no tendency to aim too high,2ZBJ24/10 Coal Mine Pneumatic Grouting Pump for Leak Sealing and Hole SealingSome small details, you can call and share with you. Have you seen our sincerity? Hongyi Xiaozhang is dedicated to serving you 24 hours a day.

　　Pneumatic grouting pump for underground useInstallation and debugging:

　　1) Open the intake valve, and at this time, the plunger rod of the pneumatic grouting pump should move back and forth, and the two discharge pipes should discharge clean water separately.

　　2) After 1 minute of trial operation, if there are no abnormal phenomena, the 2 slurry pipes can be connected to the convergence device, high-pressure valve, and grouting hole pipe to prepare for grouting.

　　3) Before connecting the gas pipeline to the pump intake pipeline, please clean the pipeline junction first, and then blow the impurities in the pipeline once before connecting to ensure the cleanliness of the gas source

　　4) Connect the two suction pipes to the suction ports respectively, and tighten them with U-shaped clamps, pipe clamps, or iron wires to prevent air leakage.

　　5) Connect the two high-pressure slurry pipes to the high-pressure tee outlet with U-shaped clamps.

　　6) Prepare a water tank, not less than 100L (old oil drums can be used to remove the cover), and fill it with clean water.

　　7) Place 2 suction pipes and faucets in the clear water tank, and also place the discharge pipe in the clear water.

　　8) Pay attention to the lubricating oil (No. 20 engine oil) in the oil mist device, observe the observation cup on the oil mist device, and adjust the handle to make the oil dripping speed about 5-6 drops/minute (the new pump has been adjusted before leaving the factory). When refueling, first remove the outer cover, push down the black button on the oil cup of the oil mist device, remove the outer cover of the oil cup, and you can refuel.

　　Next, let's take a look2ZBJ24/10 Coal Mine Pneumatic Grouting Pump for Leak Sealing and Hole SealingPrecautions for operation:

　　1. The suction pipe faucet should be placed completely below the liquid level of the slurry, and air should not be sucked in. The suction pipe faucet should not be removed and directly used to suction slurry.

　　2. Ensure that the slurry is stirred evenly and there are no large particles or foreign objects entering the suction pipe.

　　3. The suction pipe and suction joint must be tightly clamped with pipe clamps or iron wires to prevent air leakage.

　　4. When injecting double liquid slurry, the same slurry cylinder should be fixed and used. (If the water glass is on the right side of the slurry tank, it is always on the right side)

　　Model selection of pneumatic grouting pump for underground use:

　　Continuously learning to do betterPneumatic grouting pump for underground useWholeheartedly devoted to research and development2ZBJ24/10 Coal Mine Pneumatic Grouting Pump for Leak Sealing and Hole SealingEfforts should be made to make coal miners more comfortable and convenient to usePneumatic grouting pump for underground useBetter done, safer, and more reliable.

AfterSalesService :

• Pneumatic grouting pump