Zongzi Expander Price Food Flour Combination Expander Grains Double Head Picture

Description :

　　Operation Method:

　　1. Tighten the head nut and the rear nut of the pulley, and tighten the belt.

　　2. When starting up, the engine should run idle normally before slowly adding a small amount of wet rice (that is, adding a small amount of water to half a meter to just wet the rice). After the puffed material comes out normally, immediately add a small amount of dry rice continuously. Due to the low starting temperature and heavy load, the throttle of the diesel engine must be turned up a bit when starting processing, and the rice should be added slowly. After the puffed fruit is formed, gradually increase the rice feeding rate, and the rice feeding rate should be based on the principle of power dragging. If rice is found to be flipped up at the inlet, it is because the machine has not yet reached normal temperature at the beginning, and there is too much rice added, causing the outlet to not have time to discharge, resulting in the rice flipping back. Stop placing the rice at this time and wait for the flipped rice to fall down before placing it again. Make sure to continue processing for 5 minutes until the temperature rises.

　　3. During processing, if rice or puffed materials are found to clump and turn back at the inlet, and steam with a burnt smoke smell is emitted, it is because there is too little rice added and the temperature rises sharply. Use a small wooden stick to remove the material that has turned back and increase the rice feeding rate. If the blockage is severe and the material cannot be unloaded, it can be shut down and disassembled again, cleaned, and restarted.

　　After the processing is completed, let the machine idle for 15-30 seconds until the residual rice inside turns yellow, then turn off the power, remove the head nut, screw, screw sleeve, and eight hole core, and clean the rice until it is clean, in preparation for the next start-up.

　　5. The puffed fruit is hard and crisp, which is related to the type of rice and moisture. It is necessary to control the small amount of rice or replace it with dry rice, or change the screw sleeve.

　　6. Precautions: The large end face of the screw sleeve and the inner plane of the head nut (after being placed inside the machine) are in contact. These two planes must not be knocked randomly and must be protected in case a small hole is accidentally knocked. Use the file to file the raised place flat. It must be kept flat. Otherwise, the two planes will be uneven, and the big Rice noodles will drill into the gap between the two planes. Drilling into the thread of the head nut and the front barrel will cause difficulty in disassembly and damage the thread.

AfterSalesService :

• Price of puffing machine