Zhongjie brand carbon dioxide storage tank, 30 cubic meter carbon dioxide storage tank manufacturer, green special equipment

Description :

　　1. The operator should be familiar with the tank process and user manual; The pressure gauge valve and safety shut-off valve must be normally open.

　　During operation, the safety requirements and measures specified in JB6898 "Safety Rules for the Use of Low Temperature Liquid Storage and Transportation Equipment" should be followed.

　　3. Fill thoroughly for initial and normal filling, and turn on the liquid level gauge before filling; When filling for the first time, high-purity carbon dioxide should be used for the carbon dioxide storage tank ..

　　4. The carbon dioxide tanker is located about 3 meters away from the storage tank. After all preparation work meets the regulations, connect the tanker infusion hose to the inlet of the storage tank ..

　　During the filling process, open the air valve and monitoring valve, and pay close attention to the liquid level gauge and monitoring valve to prevent overloading (filling coefficient 0.6).

　　The design pressure should be taken according to GB150, and the design temperature is generally around -40 ℃. The material used is 16MnDR, but stainless steel can also be used. The corrosion allowance of stainless steel can be taken as 0. If the interface is used, it is basically the same as that of a general container, except for the inlet and outlet, gas phase inlet, filling port, safety valve interface, etc. More conventional oxygen, nitrogen, and argon storage tanks need to consider manholes and sewage outlets. If vacuum powder is used for insulation (better insulation effect than foam insulation, longer service life, but higher cost). For vertical leg structures, pull and sling structures or a combination of lower head pillars and pull straps are usually used; For horizontal saddle structures, rubberwood support structures are usually used, but strap structures can also be used. Foam insulation is relatively simple and cost-effective. The outer surface of the foam layer is usually protected by a thin aluminum plate, and no support is needed between them.

AfterSalesService :

• carbon dioxide cylinder