Guangzhou low-temperature liquid oxygen storage tank manufacturer specifications for 20 cubic low-temperature storage tanks

Description :

　　Tank filling process for liquid oxygen, liquid argon, and liquid nitrogen storage tanks

　　an instruction manual; The pressure gauge valve and safety shut-off valve must be normally open.

　　2. During operation, the safety requirements and measures specified in JB6898 "Safety Rules for the Use of Low Temperature Liquid Storage and Transportation Equipment" should be followed.

　　3. Fill thoroughly for initial and normal filling, and turn on the liquid level gauge before filling;

　　During the initial filling, the liquid storage tank is purged, replaced, and cooled with corresponding high-purity gas to achieve the required purity.

　　4. The liquid tanker is about 3 meters away from the storage tank. After all preparation work meets the regulations, connect the tanker infusion hose to the inlet of the storage tank. When the tanker is opened

　　When liquid is sprayed out, open the inlet valve of the storage tank, close the blow off valve, and fill the liquid into the storage tank.

　　5. Monitor the vent valve and closely monitor the liquid level gauge and monitoring valve to prevent overloading (filling coefficient of 0.95).

　　6. When the monitoring valve sprays liquid, immediately stop filling and close the tanker.

　　7. After draining the residual liquid and gas from the infusion tube, remove the infusion hose.

AfterSalesService :

• Low temperature liquid oxygen storage tank