350Y metal orifice plate corrugated stainless steel corrugated regular packing, perforated corrugated packing, wire mesh corrugated packing

Description :

　　350Y metal orifice plate corrugated metal regular packing: Regular packing, due to its regular, uniform, and symmetrical structure, specifies the gas-liquid flow path, improves channel and wall flow phenomena, and has the advantages of low resistance, high flux, and high diversion efficiency. It has been widely used in towers in many fields such as fine chemicals, petrochemicals, and fertilizers.

　　350Y metal orifice plate corrugated metal orifice plate corrugated packing: It is a regular packing assembled by punching and rolling small and large ripples on the surface of metal thin plates. It has the characteristics of low resistance, uniform gas-liquid distribution, high efficiency, high flux, and less obvious amplification effect. It is used in negative pressure, normal pressure, and pressure operations.

　　Large diameter regular packing needs to be installed in blocks from the manhole inside the tower. The height of the tray is usually 100-300mm, and the length of each block can be the same as the chord length of the tower, or it can be divided into several blocks. For the convenience of production, packaging, transportation, and disassembly, the length of each piece should not exceed 1.8m. The filler pieces in each piece of filler are assembled by threading nails, and sometimes simply tied with metal wires or packing straps. To prevent deformation of the wire mesh filler during transportation, metal corner protectors are used to protect the filler.

　　If the anti wall flow ring is integrated with the packing, the anti wall flow ring must be opened as required before installing each packing; If the anti wall flow ring and packing are separated, the anti wall flow ring should be placed in the required position during installation. Usually, installation starts from one end and ends at the other, with adjacent disks of packing forming a 90 degree angle. Every four trays of packing form a cycle, so rotating the packing tray in a clockwise (or counterclockwise) direction can reduce the horizontal error of the upper end face of the packing. After installing each tray of wire mesh packing, remove the corners. Installation personnel should not stand in the middle of the tower section, as this can easily form a "pot bottom" phenomenon with high circumference and low middle.

　　After assembling each tray of packing, one piece needs to be installed with the help of a skateboard. Due to the non roundness of the tower and other reasons, it is sometimes necessary to add or remove pieces of packing as appropriate to make the packing suitable for the tower body. Installing the packing too tightly can cause deformation of the packing sheet, increase the total height of the packing, make the upper end face uneven, and decrease the efficiency flux. Similarly, if the packing is installed too loosely, it can lead to uneven gas-liquid distribution and a decrease in separation efficiency.

　　In some special cases, due to time constraints or other reasons, the tray tower cannot be replaced with regular packing tower rings. It is necessary to make some packing with a diameter that matches the tower ring for installation at the tower ring. The design should consider the efficiency and flux losses caused by this

　　Dier Chemical Packing Co., Ltd., Pingxiang City, Jiangxi ProvinceWe can produce various materials according to customer needs: Ball rings, step rings, saddle rings, conjugate rings, Rascal rings, flower garlands, multi-faceted hollow balls, floating balls, plastic snowflake ringsEnvironmental BallYingteluos, orifice plate corrugated packing, wire mesh corrugated packing and tower internals, trough distributor, gas-liquid distributor, wire mesh demister, hump support, packing grid pressure grid, float valve tray, bubble cover tray, etc

　　Dier Chemical Packing Co., Ltd., Pingxiang City, Jiangxi ProvinceWe can produce various products according to customer needs and provide a comprehensive system of design, production, and installation services; Please consult the sales department for details;

　　We will exchange your utmost trust and satisfaction with the most reasonable prices and the best service quality.

AfterSalesService :

• 350Y metal orifice plate ripple