Sewage treatment aeration fan environmental protection project supporting water treatment high-pressure vortex blower

Description :

Sewage treatment aeration fan environmental protection project supporting water treatment high-pressure vortex blower

　　Feature Introduction

　　1. Aluminum die-casting impeller: generates stable airflow and efficient flow rate

　　2. Dynamic balancing impeller: smoother operation, no vibration during operation

　　3. Double covered bearings: prevent grease leakage and increase the reliability of operation

　　4. Dustproof shaft seal: prevents dust intrusion and extends bearing life

　　5. Combination of motor spindle and impeller inlay: There is no need for connectors, belts, or gears, and there is no concern of breakage or wear

　　6.50/60HZ and wide voltage design: reduces manufacturer's inventory demand for 220V to 660V voltage

　　7. High efficiency cooling fan: effectively cools the motor and air pump, enabling them to operate efficiently and with low noise

　　8. Embedded thermal protector (optional): More effective in preventing motor overheating and enhancing product reliability

　　9. Miniaturization design: allowing users to use and install space more effectively

　　10. Detachable fittings (optional): easier to install

Vortex air pumpInstallation instructions:

1. The high-pressure fan should be placed in a relatively stable place, and the surrounding environment should be clean, dry, and well ventilated.

2. The rotation direction of the high-pressure fan impeller must be in the direction indicated by the arrow on the fan casing.

3. When the high-pressure vortex fan is working, the working pressure should not exceed 8kPa to avoid excessive heat generated by the fan and damage to the air pump caused by motor overcurrent.

4. The filter screens and noise reduction devices at both ends of the high-pressure fan inlet and outlet should be cleaned in a timely manner according to the situation to avoid blockage and affect the use of the explosion-proof high-pressure fan.

5. The external connection of the inlet and outlet of the high-pressure fan must be made using flexible hoses (such as rubber hoses, plastic spring hoses).

6. Replacement of bearings for high-pressure fans: The replacement of bearings must be carried out by personnel familiar with repair work. First loosen the screws on the pump cover, and then disassemble the parts one by one according to the order shown in the diagram. The disassembled parts should be cleaned, and then assembled in reverse order. When disassembling, do not forcefully pry the impeller. Use a dedicated roller to remove it, and do not miss the adjusting gasket to avoid affecting the clearance that has been adjusted before leaving the factory.

Sewage treatment aeration fan environmental protection project supporting water treatment high-pressure vortex blower

AfterSalesService :

• Sewage treatment aeration fan