Manufacturer supplies FR-3 electric pre twisted wire shock absorber for fiber optic cable protection fittings

Description :

　　Introduction to Fiber Optic Cable Anti Shock Hammer:

　　The fiber optic cable anti vibration hammer adopts a special tuning fork structure, which can generate four resonant frequencies and effectively cover the vibration frequency range of the fiber optic cable in reality. After installing an anti vibration hammer, the amplitude of the optical cable significantly decreases, and the frequency that can form stable vibration is particularly rare, so satisfactory anti vibration effect can be achieved.

　　Fiber optic cable shock absorber material:

　　Hammer head - hot-dip galvanized cast iron;

　　Hanging wire - special 19 strand hot-dip galvanized steel stranded wire;

　　Wire clamp - aluminum alloy;

　　Protective wire - aluminum alloy.

　　Usage guide:

　　1. The anti vibration hammer cannot be directly installed on ADSS/OPGW optical cables.

　　2. Calculate the installation distance according to the formula. If it falls on the pre twisted wire of the metal protective wire, it should be installed as usual (directly installed on the pre twisted wire of the metal protective wire); If it exceeds the pre twisted wire of the metal fitting protective wire, an anti vibration hammer protective wire should be installed, and the distance between the end of the anti vibration hammer protective wire and the end of the pre twisted wire of the metal fitting protective wire should be greater than 70mm.

　　3. The large hammer head at the low-frequency end of the anti vibration hammer is facing towards one end of the tower.

AfterSalesService :

• Fiber optic cable shock hammer