Which is the good crushing machine for Hengxing ore dressing equipment

Description :

　　Working principle of jaw crusher:

　　PEThePEXThe series jaw crusher is powered by an electric motor, which drives an eccentric shaft through a belt pulley, a V-belt, and a groove wheel. The moving jaw moves back and forth according to a predetermined trajectory, thereby crushing the material entering the crushing chamber composed of a fixed jaw plate, a movable jaw plate, and an edge guard plate, and discharging the finished material through the lower discharge port. The crushing method of this series of jaw crushers is the curved extrusion type. The electric motor drives the belt and pulley, and the moving jaw moves up and down through an eccentric shaft. When the moving jaw rises, the angle between the elbow plate and the moving jaw increases, thereby pushing the moving jaw plate closer to the fixed jaw plate. At the same time, the material is subjected to multiple crushing processes such as compression, rubbing, and grinding; When the moving jaw descends, the angle between the elbow plate and the moving jaw decreases, and the moving jaw plate separates from the fixed jaw plate under the action of the pull rod and spring. At this time, the crushed material is discharged from the lower mouth of the crushing chamber, and as the electric motor continues to rotate, the moving jaw of the crusher performs periodic crushing and discharging, achieving mass production.

　　Structure composition of jaw crusher:

　　The structure of E Po mainly consists of a frame, eccentric shaft, large pulley, flywheel, movable jaw, side guard plate, elbow plate, elbow plate rear seat, gap adjusting screw, reset spring, fixed jaw plate and movable jaw plate, among which the elbow plate also plays a role.

　　Performance characteristics:

　　oneSimple structure and easy maintenance and use; Stable performance and low operating costs; High fragmentation ratio;

　　twoThe crushing chamber is deep and has no dead zone, which improves the feeding capacity and output;

　　threeIts crushing ratio is large, and the product particle size is uniform;

　　fourThe gasket type discharge port adjustment device is reliable and convenient, with a large adjustment range, increasing the flexibility of the equipment;

　　fiveThe lubrication system is reliable, the components are easy to replace, and the maintenance workload is small;

　　sixSimple structure, reliable operation, and low operating costs;

　　sevenEquipment energy saving: single machine energy savingfifteen～thirtyThe system can save more than twice the energy;

　　eightThe adjustment range of the discharge port is large, which can meet the requirements of different users;

　　nineLow noise and minimal dust.

　　 Structural features:

　　High strength manganese steel is used for one-time molding casting, which has the advantages of wear resistance, compression resistance, and long service life. Mainly suitable for crushing large, medium, and small stones and corresponding objects.

　　 Notes:

　　Before use, the fasteners of each part of the machine should be checked, especially the lubrication parts and bolts. Adequate oil should be maintained in each lubrication part, and loose bolts should be tightened. Then, the residual material in the crushing chamber should be cleaned before starting production. During normal operation, pay attention to uniform feeding, and do not feed too much at once or add too much at a time. Excessive feeding can cause mechanical blockage. Moving and static jaw plates, side guards, and top plates are vulnerable parts, please pay attention to maintenance.

AfterSalesService :

• crusher