2JP15 scraper winch quotation Shandong winch customized middling coal scraper winch has a long service life

Description :

　　The 2JP15 rake winch is mainly used for underground or open-pit ore handling and filling operations in metal mines, coal mines, and other mining sites. It is mainly used for horizontal raking and can also be used for raking on slopes with a horizontal or inclination angle of no more than 44 °. It cannot be used as a lifting equipment. The driver can operate the winch by hand or use buttons to operate the distance from a distance of several meters to tens of meters from the winch.

　　Structure description of 2JP15 ore winch

　　The 2JP15 rake winch consists of a deceleration device, a main drum, an auxiliary drum, a control device, a steel rope guide device, and an electric motor. These components are installed inside and outside the shell, which is a component with good rigidity, providing protection, support, and bearing all loads. It is fixed on two slides connected to the foundation with bolts. The double drum winch has a main drum (installed on the right side, close to the motor) and a secondary drum (installed on the left side). The three drum winch has a main drum (installed in the middle) and two auxiliary drums (installed on the left and right). The three drum winch can also be equipped with two main drums (installed on the right and middle) and one auxiliary drum (installed on the left), each of which has a corresponding control device and a steel rope guide device.

　　The significance of the 2JP15 ore winch model

　　2JPB-15L

　　2- Number of rolls

　　J - Windmill type

　　P - Mining winch

　　B - Isolation, non isolated explosions are not marked

　　15- Electric motor power; KW

　　L - Remote control, manual control without marking.

　　Model example: 2PJB15 represents an explosion-proof double drum rake mining winch with an electric motor power of 15KW.

　　Technical parameters of 2JP15 ore winch

　　The average tension of the main steel wire rope shall not be less than KN: 14 square meters

　　Average speed ± 5% m/s: Main wire rope: 1.1 Secondary wire rope: 1.5

　　Wire rope diameter mm: Main wire rope: 12.5 Secondary wire rope: 11.0

　　Roll: Diameter mm: 225 Wheel rim diameter mm: 435 Width mm: 125

　　Rope capacity: main drum m: 80 auxiliary drums m: 100

　　Motor: Model: YB160L-4 Power KW: 15 Speed r/min: 1460. zmjt055

AfterSalesService :

• 2JP15 mining winch