Technical parameters of side dump mining truck, manufacturer of side dump mining truck

Description :

　　Structural composition of side dumping mine car

　　The side dumping mining car consists of the following components: 1. carriage, 2. chassis, 3. wheel axle, 4. unloading wheel, 5. support spring, 6. buffer rubber spring and joint. The connection between the carriage and the bottom frame adopts a hinge form, which allows the mining car to open a certain angle when passing through the unloading station, so that the ore can be unloaded smoothly.

　　1. The front, rear, and side panels of the carriage are welded with 12mm thick 16Mn plates, and reinforced with groove shaped steel plates on the outer sides of the carriage; The wing plates are welded to the left and right side plates respectively, and the upper part is welded into a mouth shape with angle steel. The upper part of the angle steel is connected to the groove steel plate, so as to prevent damage to the carriage even in extremely harsh working environments.

　　2. Car chassis. The bottom plate is made of 25mm thick steel plate, and angle steel and steel plate are welded under the bottom plate to withstand the impact force of ore on the bottom plate during ore loading.

　　3. Wheel axle. The axle is composed of an axle, wheels, and rubber spring seats.

　　4. Unload the wheel. When the mining car unloads ore, the unloading wheel starts working when the mining car passes through the unloading station. It rolls along the curved track to open the bottom plate of the mining car. After unloading the ore, it closes the bottom plate and returns to the loading state.

　　5. Buffer rubber spring and connector. Buffer and header are installed at both ends of the mining car, mainly composed of buffer rubber springs, headers, pins, and single loop chains. It can alleviate and reduce the impact force between mining cars, extending the service life of the vehicle.

　　6. Supporting springs. This mining car adopts rubber springs as vibration reduction devices, expanding the inclination angle of the rubber springs during installation to enable them to withstand greater impact loads.

　　Introduction to Side Unloading Mining Car Products

　　Side dumping mining car is an efficient and self unloading operating equipment that does not have the capability and needs to be used in conjunction with a traction locomotive for mining loading and unloading. One or both sides of the car can be opened, and the ore unloading curved track installed on the unloading point is used to tilt the mining car. The pull rod opens the side door to unload the ore.

　　Scope of Application for Side Unloading Mining Cars

　　Side dumping mining cars are suitable for transporting ores or other materials along underground tunnels and surface work sites in metal mines (or other mines with similar ore properties and mining methods) that are mined underground or on the ground. Compared with other bottom dump mining cars, this mine car has smooth operation and less impact on electric locomotives and tractors, which can extend its service life. The car is sturdy and durable, easy to maintain, and can be unloaded in both directions with high unloading speed.

　　Parameters of Side Unloading Mining Car

　　Volume: 1.6m3

　　Track gauge: 600

　　Wheelbase: 800C

　　Wheel diameter: 350D

　　Traction height: 320h

　　Rated traction force: 60KN

　　Unloading angle: ≥ 42 °

　　Loading capacity: 4000KG

　　Dimensions: (length * width * height) 2500 * 1200 * 1300 zmjt055

AfterSalesService :

• Side-discharging mine car