LDE-350 Intelligent Electromagnetic Flow Meter

Description :

　　LDE-350 Intelligent Electromagnetic Flow Meter

　　This product is widely used in industries such as petroleum, chemical, metallurgical, textile, food, pharmaceutical, papermaking, as well as environmental protection, municipal management, water conservancy construction, etc. to measure high temperature, high humidity, and difficult to observe environments.

　　1、 Characteristics:

　　1. Electromagnetic flowmeter is an instrument for measuring volumetric flow rate. The measurement of flow rate is not affected by changes in fluid density, viscosity, temperature, pressure, and conductivity. The sensor induced voltage signal is linearly related to the average flow rate, and the measurement accuracy is high.

　　2. There is no obstruction or moving parts inside the measuring tube, which will not cause additional energy loss or blockage. Therefore, the energy-saving effect is significant, especially suitable for measuring liquid-solid two-phase flows such as sewage, mud, slurry, coal water slurry, pulp, etc.

　　3. Electromagnetic flowmeter has no mechanical inertia, sensitive response, can measure instantaneous pulsating flow, and has good linearity.

　　4. The installation requirements are low, and the straight pipe section required for the sensor is relatively short, usually in the first 5D and then 3D (D is the inner diameter of the selected instrument).

　　5. The sensor part only has the lining and electrodes in contact with the medium. As long as the electrode and lining materials are selected reasonably, they can be corrosion-resistant and wear-resistant, ensuring long-term use.

　　6. When power is off, EEPROM can protect set parameters and accumulated values.

　　LDE-350 Intelligent Electromagnetic Flow Meter

　　2、 Technical parameters:

　　Accuracy level: ± 0.5%, ± 1%

　　Lining materials: polyurethane, chloroprene rubber, polytetrafluoroethylene, etc

　　Electrode materials: stainless steel, Hastelloy, titanium, platinum iridium alloy, etc

　　Connection methods: flange clamping, flange connection, etc

　　Medium temperature: 0 ℃~70 ℃, 0 ℃~130 ℃ (0 ℃~180 ℃)

　　Nominal pressure: 1.0Mpa~32 Mpa

　　Protection level: IP65, IP68

　　Explosion proof mark: ExibBT4

　　Working voltage: 220VAC, 24VDC

　　3、 Attention:

　　1. The ambient temperature or the radiation temperature on the surface of the flowmeter converter is greater than 60 ℃.

　　2. In situations where pipeline vibration is significant.

　　3. In situations where the aluminum casing of the converter is severely corroded by corrosive gases.

　　4. In places with high humidity or corrosive gases on site.

　　5. Flow meters are installed in high-altitude or underground environments where debugging is inconvenient.

AfterSalesService :

• LDE electromagnetic flowmeter