LDE-250 Intelligent Electromagnetic Flow Meter

Description :

　　LDE-250 Intelligent Electromagnetic Flow Meter

　　This product has a simple and reliable structure, no movable parts, and a long working life. No flow blocking components, no pressure loss or fluid blockage. The measurement accuracy is not affected by the type of measured medium and its physical parameters such as temperature, viscosity, density, pressure, etc.

　　1、 Product features:

　　1. Suitable for volumetric flow measurement of conductive fluids with conductivity greater than 5 ц s/cm.

　　2. There are no active or obstructed components inside the measuring tube, and the pressure loss is small.

　　3. Lining and electrodes made of different materials have good anti-corrosion performance.

　　4. Not affected by medium, density, viscosity, temperature, pressure, and conductivity.

　　5. Low frequency rectangular wave excitation, less susceptible to interference, stable and reliable.

　　6. The converter has low energy consumption, simple and convenient installation, and users do not need to debug.

　　LDE-250 Intelligent Electromagnetic Flow Meter

　　2、 Technical parameters:

　　Accuracy level: ± 0.5%, ± 1%

　　Lining materials: polyurethane, chloroprene rubber, polytetrafluoroethylene, etc

　　Electrode materials: stainless steel, Hastelloy, titanium, platinum iridium alloy, etc

　　Connection methods: flange clamping, flange connection, etc

　　Medium temperature: 0 ℃~70 ℃, 0 ℃~130 ℃ (0 ℃~180 ℃)

　　Nominal pressure: 1.0Mpa~32 Mpa

　　Protection level: IP65, IP68

　　Explosion proof mark: ExibBT4

　　Working voltage: 220VAC, 24VDC

　　3、 Selection of installation location:

　　1. The flow direction indicator on the sensor must be consistent with the direction of the measured medium flow inside the pipeline.

　　2. The installation position must ensure that the measuring tube is filled with the measured medium.

　　3. Choose a location with smaller fluid flow impulse, which should be away from the pump and local resistance components (valves, elbows, etc.)

　　4. When measuring two-phase fluids, a location that is not prone to phase separation should be selected.

　　5. Installation in areas with negative pressure inside the pipe should be avoided as much as possible.

　　6. When the measured medium easily causes adhesion and scaling on the inner wall of the electrode and measuring tube, it is recommended that the flow velocity inside the measuring tube should not be less than 2m/s.

AfterSalesService :

• LDE electromagnetic flowmeter