Carbon steel LDE-65 electromagnetic flowmeter

Description :

　　Carbon steel LDE-65 electromagnetic flowmeter

　　This product can not only meet on-site display requirements, but also output 4-20mA current signals for recording, adjustment, and control. It has been widely used in industrial technology and management departments such as chemical, environmental protection, metallurgy, medicine, papermaking, and water supply and drainage.

　　1、 Characteristics:

　　The measurement of flow rate is not affected by changes in fluid density, viscosity, temperature, pressure, and conductivity. The sensor induced voltage signal is linearly related to the average flow rate, resulting in high measurement accuracy (0.3-0.5%).

　　There is no obstruction in the measuring pipeline, so there is no additional pressure loss, which has significant energy-saving significance.

　　There are no movable parts inside the measuring pipeline, so the sensor has a long lifespan.

　　The straight pipe section required for the sensor is relatively short, making it easy to install.

　　Reasonable selection of electrode and lining materials can resist corrosion and wear.

　　Carbon steel LDE-65 electromagnetic flowmeter

　　2、 Technical data:

　　Nominal diameter: DN6-3000mm

　　Nominal force: 0.6, 1.0, 1.6, 4.0 MPa (high pressure can be processed according to user requirements)

　　Accuracy: ± 0.2% ± 0.5% (indication error)

　　Measurement range (flow rate): 0-1m/s to 0-10m/s

　　Medium temperature: Split type -10 ℃~+80 ℃ (PTFE and F46 lining -40 ℃~+180 ℃) Integrated type -10 ℃~+80 ℃

　　Environmental temperature: -25 ℃~+60 ℃

　　Environmental humidity: 5~RH (relative humidity)

　　Dielectric conductivity: greater than 20 μ S/cm

　　Installation: integrated type, split type

　　3、 Installation:

　　In order to ensure the stable and reliable operation of the flowmeter, the following requirements should be noted when selecting the installation location:

　　1. Try to avoid ferromagnetic objects and equipment with strong electromagnetic fields (such as large motors, transformers, etc.) to prevent the magnetic field from affecting the working magnetic field and flow signal of the sensor.

　　2. It should be installed in a dry and ventilated place as much as possible, avoiding direct sunlight and rain. The ambient temperature should be between -20 and+60 ℃, and the relative humidity should be less than 85%.

　　3. There should be ample space around the flowmeter for easy installation and maintenance.

AfterSalesService :

• LDE electromagnetic flowmeter