Remote transmission LDE-500 electromagnetic flowmeter

Description :

　　Remote transmission LDE-500 electromagnetic flowmeter

　　This product is a volumetric flow measurement instrument that is not affected by the temperature, viscosity, density, or conductivity (within a certain range) of the measured medium during the measurement process. Therefore, after being calibrated with water, the flowmeter can be used to measure the flow rate of other conductive liquids.

　　1、 Category:

　　The FH-1000 series electromagnetic flowmeter consists of a sensor and an intelligent signal converter. According to the assembly form of the converter and sensor, it can be divided into two structures: integrated and split.

　　Integrated: The converter and sensor are directly assembled as a whole and cannot be separated. Commonly used in sites with good environmental conditions.

　　Split type: The converter is composed of a dedicated cable and a sensor to form a product, with the sensor installed on site and the converter installed in a location with better conditions. Commonly used in sites with poor environmental conditions, such as underground wells, high temperatures, and places that are difficult for personnel to reach.

　　Remote transmission LDE-500 electromagnetic flowmeter

　　2、 Technical parameters:

　　Sensor section

　　Applicable pipe diameter: DN15~DN1000, other diameters are non-standard and can be customized according to user requirements.

　　Measurement tube lining material: F46 (perfluoroalkoxy, polytetrafluoroethylene), P0 (polyolefin), PUR (polyurethane)

　　Electrode materials: 316L, Hc (Hastelloy C), Hb (Hastelloy B), Ti (Titanium), Ta (Tantalum)

　　Working pressure: DN15~DN80 caliber: 4.0MPa (standard)

　　DN100~DN150 caliber: 1.6MPa (standard)

　　DN200~DN1000 caliber: 1.0MPa (standard)

　　Exceeding the above pressure standards is non-standard and can be customized according to user requirements.

　　Fluid temperature: P0 lining: -20 ℃~80 ℃; PUR lining: 0-50 ℃

　　F46 lining: -40 ℃~130 ℃ (wide temperature type), 130 ℃~180 ℃ (high temperature type)

　　Process connection flange: The flange standard in this book is GB/T9119-2000, and other standard flanges can also be customized according to user requirements.

　　Grounding ring material: 304, 321, 316 Hc、Ti、Cu

　　3、 Installation:

　　1. Try to avoid ferromagnetic objects, high radio frequency, strong vibration interference sources, and equipment with strong electromagnetic fields (such as high-power motors, large transformers, etc.) to avoid magnetic fields affecting the working magnetic field and flow signal of the sensor.

　　2. It should be installed in a dry and ventilated place as much as possible, and should not be installed in damp or water prone areas.

　　3. It is advisable to avoid direct sunlight and rain as much as possible, and the ambient temperature should be between -20 and 60 ℃ with a relative humidity of less than 95%.

　　4. Choose a place that is easy to maintain and has convenient activities.

　　5. The flowmeter should be installed at the rear end of the water pump and must not be installed on the suction side; The valve should be installed on the downstream side of the flow.

AfterSalesService :

• LDE electromagnetic flowmeter