Supply LDE-80 electromagnetic flowmeter

Description :

　　Supply LDE-80 electromagnetic flowmeter

　　This product is mainly used to measure the volumetric flow rate of conductive liquids and slurries in closed pipelines. Including highly corrosive liquids such as acids, alkalis, salts, etc.

　　1、 Characteristics:

　　1. There are no movable parts inside the measuring tube, and the sensor has a long service life.

　　2. There are no resistance components inside the tube, so there is no additional pressure loss, no blockage, and reliable measurement.

　　3. Strong anti-interference ability, small size, light weight, easy installation, low maintenance, and wide measurement range.

　　4. Measurement is not affected by changes in fluid temperature, density, pressure, viscosity, conductivity, etc.

　　5. It can be cut, modified and installed on old pipelines, with simple construction and small engineering quantity.

　　6. Compared with general flow meters, it has low cost and installation expenses, making it particularly suitable for measuring flow in large and medium-sized pipelines.

　　7. The sensing voltage signal of the sensor is linearly related to the average flow rate, therefore the measurement accuracy is high.

　　8. Chinese LCD display, displaying cumulative flow, instantaneous flow, flow rate, flow percentage, etc.

　　Supply LDE-80 electromagnetic flowmeter

　　2、 Technical parameters:

　　1. nominal pressure: ordinary DN (4-80) -4.0MPa; DN（100～150）—1.6MPa；

　　DN（200～1000）—1.0MPa； DN（1100～2000） —0.6MPa。

　　High pressure DN (4-80) -6.3MPa, 10 MPa, 16 MPa, 25 MPa, 32 MPa;

　　DN（100～150）—2.5 MPa，4.0 MPa，6.3 MPa，10 MPa，16 MPa；

　　DN（200～600）—1.6 MPa，2.5 MPa，4.0 MPa；

　　DN（700～1000）—1.6 MPa，2.5 MPa；

　　DN（1100～2000）—1.0 MPa，1.6MPa。

　　2. Accuracy level: 0.2, 0.5 (indication error)

　　3. Flow velocity range: (0.1-15) m/s

　　4. Fluid conductivity: ≥ 5uS/cm

　　5. Protection level: IP65 (waterproof type), IP68 (submersible type)

　　6. Fluid temperature: (-30~+180) ℃

　　7. Working environment: (-25~+55) ℃, 5%~95% RH

　　8. Connection method: flange connection (GB9119-1988) or ANSI standard

　　9. Output signal: (0-1) kHz, (4-20) mA, or (0-10) mA

　　10. Power supply: 220VAC, 50Hz or 24VDC.

　　3、 Installation:

　　1. When measuring mixed phase fluids, choose a location that will not cause phase separation. When measuring two-component liquids, avoid installing them downstream where mixing is not yet uniform. When measuring chemical reaction pipelines, they should be installed in the fully completed reaction section.

　　2. Try to avoid negative pressure inside the measuring tube as much as possible.

　　3. Choose a location with low vibration, especially for integrated instruments.

　　4. Avoid large motors, transformers, etc. nearby to prevent electromagnetic interference.

　　5. A place that is easy to implement separate grounding for sensors.

　　6. Try to avoid high concentrations of corrosive gases in the surrounding environment as much as possible.

AfterSalesService :

• LDE electromagnetic flowmeter