LDG-80 electromagnetic flowmeter price

Description :

　　LDG-80 electromagnetic flowmeter price

　　This product is available in various flow meter models such as pipeline type and plug-in type. Using EEPROM memory, the storage of measurement and operation data ensures safety and reliability. It has two types: integrated and separated, and has been widely used in the measurement of various conductive liquids in industry.

　　1、 Selection:

　　According to the national standard GB4208-84 and the World Electrotechnical Commission standard IEC529-76, the regulations for the protection level of electrical products' enclosures are as follows:

　　1. IP65: For anti spray type, the sensor housing of the electromagnetic flowmeter allows the faucet to spray water on the sensor from any direction of the electromagnetic flowmeter, with a pressure of 30Kpa, a water output of 12.5L/s, and an interval of 3 meters.

　　2. IP67: The electromagnetic flowmeter sensor can be used for short-term immersion in water.

　　3. IP68: It is a submersible type, suitable for long-term operation in water or underground under certain pressure. At this moment, the sensor and display of the electromagnetic flowmeter are somewhat separated, and a modular electromagnetic flowmeter needs to be made, but it is necessary to pay attention to the protection level requirements of the electromagnetic flowmeter.

　　LDG-80 electromagnetic flowmeter price

　　2、 Characteristics:

　　1. The range of electromagnetic flowmeter is wide.

　　2. In addition to measuring the volumetric flow rate of general conductive liquids, electromagnetic flow meters can also be used to measure strongly corrosive liquids such as strong acids and alkalis, as well as slurries, slurries, and pulp.

　　3. A bidirectional measurement system that can measure both forward and reverse flow rates.

　　4. The measurement results of electromagnetic flowmeter are independent of physical parameters such as pressure, temperature, density, viscosity, conductivity, and are not affected by the environment.

　　5. Electromagnetic flowmeter has reliable performance, high accuracy, low power consumption, stable zero point, and convenient parameter setting. Click on the Chinese display LCD to show accumulated flow, instantaneous flow, flow rate, flow percentage, etc.

　　3、 Technical parameters:

　　Nominal diameter (mm) (special specifications can be customized)

　　Pipeline type PTFE lining: DN10~DN600

　　Pipeline rubber lining: DN40~DN2200

　　Flow direction: positive, negative, net flow

　　Range ratio: 150:1

　　Repetitive error: ± 0.1% of the measured value

　　Accuracy level: Pipeline type: 0.5 level, 1.0 level

　　Temperature of the tested medium: ordinary rubber lining: -20 to+60 ℃; High temperature rubber lining: -20 to+90 ℃

　　PTFE lining: -30 to+100 ℃; High temperature PTFE lining: -20 to+180 ℃

　　Rated working pressure: (high pressure can be customized) DN10- DN150: ≤ 1.6MPa; DN200－DN350：≤1.0MPa

　　DN400－DN1000：≤0.6MPa； DN450－DN2200：≤0.25MPa

　　Flow velocity range: 0.1-15m/s

AfterSalesService :

• LDG electromagnetic flowmeter