Intelligent DN100 electromagnetic flowmeter

Description :

　　Intelligent DN100 electromagnetic flowmeter

　　This product is a volumetric flow measurement instrument that is not affected by the temperature, viscosity, density, or conductivity (within a certain range) of the measured medium during the measurement process. Therefore, after being calibrated with water, the flowmeter can be used to measure the flow rate of other conductive liquids.

　　1、 Classification

　　The FH-1000 series electromagnetic flowmeter consists of a sensor and an intelligent signal converter. According to the assembly form of the converter and sensor, it can be divided into two structures: integrated and split.

　　Integrated: The converter and sensor are directly assembled as a whole and cannot be separated. Commonly used in sites with good environmental conditions.

　　Split type: The converter is composed of a dedicated cable and a sensor to form a product, with the sensor installed on site and the converter installed in a location with better conditions. Commonly used in sites with poor environmental conditions, such as underground wells, high temperatures, and places that are difficult for personnel to reach.

　　Intelligent DN100 electromagnetic flowmeter

　　2、 Performance indicators

　　Flow velocity measurement range: (0.05-10) m/s

　　Power consumption:<15VA

　　Protection level: IP68

　　Connection method: flange connection

　　Electrode materials: molybdenum containing stainless steel OCr18Ni12Mo2Ti, Hastelloy B, Hastelloy C, titanium Ti, tantalum, etc

　　Measuring pipeline diameter: DN (32-6000) mm

　　Instrument accuracy: Level 1.0

　　Work pressure: ≤ 1.6MPa

　　Medium temperature: 0-80 ℃

　　3. Installation

　　⑴ Try to avoid ferromagnetic objects, high radio frequency, strong vibration interference sources, and equipment with strong electromagnetic fields (such as high-power motors, large transformers, etc.) to avoid magnetic fields affecting the working magnetic field and flow signal of the sensor.

　　⑵ It should be installed in a dry and ventilated place as much as possible, and should not be installed in damp or water prone areas.

　　⑶ Avoid direct sunlight and rain as much as possible, and the ambient temperature should be between -20 and 60 ℃ with a relative humidity of less than 95%.

　　⑷ Choose a place that is easy to maintain and has convenient activities.

　　The flowmeter should be installed at the rear end of the water pump and must not be installed on the suction side; The valve should be installed on the downstream side of the flow.

AfterSalesService :

• DN100 electromagnetic flowmeter