Foam fire hydrant model price use and maintenance foam fire extinguishing equipment manufacturer

Description :

　　Foam fire hydrant is one of the important devices in the foam fire extinguishing system, especially suitable for the production, storage and use of large areas of flammable liquids and flammable liquids with fire hazards. Foam fire hydrant is mainly composed of flange, cylinder, ball valve, internal connection, fire pipe thread and end cover. The ground foam fire hydrant can be divided into three models: PSS80-65X2, PSS100-65X2 and PSS150-65X2 according to the flange interface. The rated working pressure of foam fire hydrant is within 1.6MPa.

　　The PS150/100-65 * 2 produced by Shandong Dongyue Crane and Fire Equipment Manufacturing Co., Ltd. has two outlet diameters of 65mm and two inlet diameters of 100/150.

　　The use and maintenance of fire hydrants should pay attention to the following points:

　　1. Regularly inspect the fire hydrant, check the opening size of the cover, remove dirt, check if the seal is intact, and repair any paint peeling.

　　2. Check and clean up any obstacles to the fire hydrant.

　　3. Fire hydrants are usually closed, and a special wrench should be used to turn them on. After each use, a drainage valve should be used to drain the remaining water to prevent freezing and damage to the hydrant body. Especially in severe winter, attention should be paid to cold prevention, and the fire hydrant should be closed to prevent freezing and cracking of the hydrant body

　　4. When closing the fire hydrant, if it is not tightly closed, it should be loosened several times and rinsed with clean water before closing. It is strictly prohibited to close it forcefully or damage the components of the hydrant.

AfterSalesService :

• Model of foam fire hydrant