Stainless steel water tank, prefabricated stainless steel water tank, galvanized steel plate water tank

Description :

stainless steel water tankPrefabricated water tank: 1. BDF module: The material selection is a BDF uniform standard size template made of 3.0mm double-layer hot-dip galvanized sheet and 0.4mm stainless steel; Simultaneously meet the requirements of steel plate material strength and stainless steel corrosion resistance.

　　2. Reinforcement: Choose a horizontal drawing of Φ 48 hot-dip galvanized steel pipe, and install it vertically and horizontally every 1 meter.

　　3. Beading: use environment-friendly, waterproof, water resistant and anti-aging rubber strips.

　　4. Prefabricated fasteners and screws: Use Dacromet galvanized high-strength screws and "cross" fasteners.

　　5. Accessories: manhole, ladder, sewage pit, anti-corrosion treatment, etc.

　　6. Pump room: The interior of the pump room is reinforced with reinforced I-beams, using 18 # I-beams for reinforcement. The equipment installation complies with the requirements of the fire pump motor in the "Technical Specification for Fire Water Supply and Fire Hydrant Systems" implemented on October 1, 2014; Ensure fire safety acceptance; Provide test reports.

stainless steel water tankThe production process standards are as follows:

　　1. The folding edge of the shaped plate should reach 4cm to ensure the strength of the water tank.

　　2. The assembly welds of the finished water tank must be full, and the external assembly welds must be flat, symmetrical, without weld beads or air holes. The internal welding seams must ensure no leakage and require successful one-time welding without leakage. The welding of the top plate of the water tank requires full welding, without missing or spot welding, and the top corner should also be fully welded. Welding must be carried out using sub arc welding and stainless steel welding rods, and non-standard welding operations are strictly prohibited.

　　3. The internal support of the stainless steel water tank should be folded into a "concave" or "angle iron" shape, and there should be no burrs or quick opening. The welding of the support should be fully welded, and spot welding is strictly prohibited to ensure the strength of the support. The spacing between support rods is generally not more than 1 meter, and the size should meet the requirements of tensile strength. For water tanks with special heights, the size of the support rods should be correspondingly enlarged.

　　4. The stainless steel water tank chassis should be welded with No. 10 channel steel to ensure flatness, and leveled with a level.

　　5. The inlet and outlet of stainless steel water tanks should be welded with SUS304 stainless steel seamless steel pipes and stainless steel flanges.

　　6. The manhole cover of stainless steel water tank should be processed in a beautiful, smooth, and seamless manner, and must be fully welded. After installation, the switch should be flexible. The material of the ladder shall ensure the bearing strength of people when climbing the ladder, and the width shall be no less than 400mm. The welding and fabrication shall be beautiful and smooth.

AfterSalesService :

• stainless steel water tank