10th Aviation Hydraulic Oil Ground Use Shenyang Teli Low Temperature Hydraulic Oil Manufacturer Agent to Issue Special Tickets
10th Aviation Hydraulic Oil Ground Use Shenyang Teli Low Temperature Hydraulic Oil Manufacturer Agent to Issue Special Tickets

10th Aviation Hydraulic Oil Ground Use Shenyang Teli Low Temperature Hydraulic Oil Manufacturer Agent to Issue Special Tickets

Category:

energy/Petroleum product additives/Lubricant additives

Model:

10th aviation hydraulic oil for ground use

Brand:

Shenyang Teli

Retail Price

350.00USD


重量

kg

  • Product Description
  • Description :

      Product Introduction

      Teli No.10 Aviation Hydraulic Oil (Sky) is the main product of Shenyang Teli Petrochemical Co., Ltd., which complies with the SH 0358-1995 "No.10 Aviation Hydraulic Oil" execution standard. It is mainly used for lubrication of various hydraulic equipment in aircraft, with a low-temperature operating temperature of up to -70 ℃. At present, it has been widely used on various models of aircraft and experimental benches of units, with a good reputation.

      This oil has the following characteristics:

      Excellent low-temperature performance, with an application temperature of up to -70 ℃, meeting the all-weather and all airspace use of aircraft

      √ Good comprehensive performance, wear resistance/compression resistance/lubrication/rust prevention, and low procurement cost

      Performance Characteristics

      Has good high temperature performance, low temperature performance, oxidation stability, and hydraulic transmission performance.

      Instructions for use

      1. It is not allowed to store or mix with other oil products.

      2. When adding oil, clean tools should be used to reduce impurities from falling in

      3. Use up as soon as possible after opening, or seal tightly when sealing again

      4. During use, check the quality of the oil on time and change the oil as needed

      Product Parameters

      Test Item

      

      parameter indicators

      

      Test results

      

      appearance

      

      Red transparent liquid, no suspended solids

      

      qualified

      

      50 ℃ kinematic viscosity, mm2/s

      

      Not less than 10

      

      ten point seven five

      

      -50 ℃ kinematic viscosity, mm2/s

      

      Not greater than 1250

      

      eight hundred and twenty-six point two

      

      Corrosion throughout, 70 ℃, 24h, grade

      

      Not greater than 2

      

      1b

      

      Initial boiling point, ℃

      

      Not less than 210

      

      two hundred and fourteen

      

      Acid value, mgKOH/g

      

      Not greater than 0.05

      

      zero point zero two

      

      Open flash point, ℃

      

      Not less than 92

      

      ninety-five

      

      Condensation point, ℃

      

      Not higher than -70

      

      Below -70

      

      moisture mg/kg

      

      Not greater than 60

      

      thirty-six

      

      Mechanical impurities,%

      

      none

      

      none

      

      Water soluble acid or base

      

      none

      

      none

      

      Product actual photos

      


    AfterSalesService :

    Key words:
    • 10th aviation hydraulic oil