Bridge pier spray curing equipment, concrete steam curing equipment, water spray mist nozzle

Description :

　　Introduction to Concrete Steam Curing Equipment

　　Concrete steam curing equipment can meet the quality standards of all-weather and all wet curing, and the curing effect is extremely significant. The spray curing device technology is a key technology for achieving large-scale standardized production of prefabricated beam segments and accelerating the construction cycle of bridges. At the same time, the spray curing device has basically achieved fully automatic control from water supply to completion of work, greatly reducing labor intensity and improving labor productivity. It has significant advantages such as low cost, easy installation and maintenance, and water conservation.

　　The cement particles that have formed the gel can not be fully hydrated, can not be converted into stable crystals, lack of sufficient cohesion, premature evaporation of water will also produce large shrinkage deformation, appear dry shrinkage cracks, affect the integrity and durability of concrete, and have a huge impact on the early strength of concrete. The watering frequency should be able to keep the concrete in a moist state, and the curing water for the concrete should be the same as the mixing water; Before the concrete strength reaches 1.2N/mm2, it is not allowed to step on or install formwork and supports on it. Under certain constraints, significant tensile stress will be generated. Due to long-term exposure of concrete, the surface is prone to tensile stress when in contact with air or water. Firstly, set the rotary switch to manual mode. When operated manually, the LCD display is normal but cannot be manually operated. Only the manual buttons on the control panel can be used for operation. First, press the water pump start button. Then, press the pedestal button to manually control the spraying time of each pedestal according to the weather, temperature, and beam length. After the spraying is completed, press the water pump stop button to end the spraying.

　　The connection diameter of the concrete steam curing equipment is 1/2 inch. 4 minutes (DN15); Water pressure is between 1.5-3KG; water flow rate is between 30-215L/H; Coverage area in atomized state: about 1 meter, 4-6 meters in water column state (water column range). This spray curing device is suitable for T-beams and box beams with wing plates. The bottom of the wing plate is a key part of automatic spray curing, and the butterfly shaped nozzle can make the bottom of the wing plate fully wet when rotating.

AfterSalesService :

• Concrete steam curing equipment