Manufacturer supplies bag cyclone dust collector for cleaning Quanzhou bag dust removal equipment

Description :

　　Ground chain

　　3.1 Lubricate the drive sprocket of the ground chain drive station once a month, and add engine oil to the transmission chain every two months.

　　3.2 The ground chain cover plate should be inspected once a week, and if the cover plate is deformed, it should be leveled in a timely manner.

　　3.3 The fixed pin of the ground chain trolley should be checked daily, and each trolley should first check whether the fixed pin is in the chain drive position when assembling and reassembling.

　　Process Design

　　To achieve a relatively high utilization rate of painting equipment, it is necessary to establish a reasonable painting production line. Firstly, the production plan should be determined, the process design and scheme planning should be improved, and then the equipment design, manufacturing and installation can be carried out. Therefore, process design and scheme planning are the foundation for establishing a production line, and a correct and reasonable process will have a decisive impact on production operations and product quality.

　　The content of process design mainly includes: pre-treatment methods for workpiece surfaces, painting methods, coating performance, spraying environment, process planning, etc.

　　Product Maintenance

　　Regularly check the operation of control valves, pulse valves, and timers.

　　The failure of the pulse valve rubber diaphragm is a common fault in bag filters, which directly affects the dust cleaning effect. This device belongs to the external filter type, with a skeleton inside the bag. It is necessary to check whether the parts that fix the filter bag are loose and whether the tension of the filter bag is appropriate. Is the support frame smooth to prevent wear and tear on the filter bag. Compressed air is used for dust removal. Therefore, it is required to remove oil mist and water droplets, and the oil-water separator must be cleaned regularly to prevent malfunction of the moving mechanism and blockage of the filter bag.

　　Whether the air volume and pressure and temperature at each testing point are consistent with the design.

　　The installation status of the 3 filter bags, whether there are any occurrences of bag dropping, loosening, wear, etc. after use, can be judged by visually observing the emissions of the chimney after operation.

　　4. Prevent condensation

　　During use, it is necessary to prevent the gas from cooling below the dew point in the bag chamber, especially when using a bag filter under negative pressure. Due to the frequent leakage of air into the outer shell, the gas temperature in the bag chamber is lower than the dew point, causing the filter bag to become damp. This results in dust not being loose but sticking to the filter bag, blocking the fabric holes and causing dust removal failure. This leads to excessive pressure drop in the dust collector, making it unable to continue operating, and some bags may become stuck and unable to remove dust.

　　To prevent condensation, it is necessary to maintain the temperature of the gas in the dust collector and its system at 25-35 ℃ above its dew point (such as the dew point temperature of 58 ℃ for kiln mill integrated machines, and the operating temperature should be above 90 ℃), in order to ensure the good use effect of the filter bag.

AfterSalesService :

• bag filter