Manufacturer supplies ZBQ-27/1.5 coal mine pneumatic grouting pump price

Description :

　　ZBQ-27/1.5 coal mine pneumatic grouting pump (referred to as grouting pump), improved on the basis of the original QB152 portable grouting pump, by compressing oil or

　　Air provides working power and is mainly used in mining, tunnel, water conservancy, subway, construction, and bridge construction. It is used for grouting and blocking water, filling gaps, and breaking rock layers

　　Grouting consolidation, anchoring grouting; It is also used for repairing local defects such as frost heave in highway and railway roadbeds, as well as for soft foundation treatment; Eliminate underground hazards in flood control and rescue operations.

　　The manufacturer of the pneumatic grouting pump for coal mines reminds you to pay attention to the operating procedures and safe operation:

　　1. Ensure that the gas source is free of excessive moisture and dirt, and that the gas source has a lubrication system. Optional oil mist generator provided by our factory.

　　2. The air source pipe should first be connected to the ventilation pipe to blow away debris, and then reliably connected to the grouting pump.

　　3. Firstly, immerse the inlet of the pump in clean water and slowly open the inlet ball valve to ensure that the grouting pipeline is unobstructed and there is no leakage at the sealing point.

　　4. The slurry should be mixed evenly, without lumps, but thick. Timely clean the solidified materials at the corners and edges of the bucket to prevent them from falling into the slurry.

　　5. Immerse the inlet of the pump into the slurry, slowly open the inlet ball valve, and gradually increase to the appropriate grouting speed.

　　6. After the pump stops working, it should be immediately immersed in clean water for flushing, and the inlet ball valve should be slowly opened until the water discharged from the slurry pipe is clear and free of slurry.

　　7. After cutting off the gas source and drainage pipe, regularly remove the screws from the flange, extract the grouting cylinder, and thoroughly remove any remaining grouting material.

　　8. After cleaning, apply lubricating grease to the metal surface of the grouting cylinder and re connect and tighten it with the pump body.

　　9. It is strictly prohibited to operate the pump at high speed with no load or light load to avoid damaging various moving parts.

　　10. The pressure of the gas source shall not exceed 0.8MPa.

　　11. At the construction site, the grouting pump should be placed with the inlet facing downwards to prevent debris from entering the inlet pipe joint and exhaust hood.

　　This grouting pump has a small volume, light weight, and reliable use. It can be used in places that are flammable, explosive, have large temperature and humidity changes

Learning from others' strengths and exploring innovation have always been our persistent pursuit. Therefore, Shandong Coal Mining Equipment Co., Ltd. will spare no effort to solve practical problems in coal mine sites and optimize production processes

We warmly welcome customers and friends to visit and provide guidance and consultation for cooperation.

AfterSalesService :

• Mining pneumatic grouting pump