Geomembrane Hot Melt Welding Machine Tunnel Waterproof Membrane Welding Machine Free Shipping

Description :

　　Geomembrane Hot Melt Welding Machine Tunnel Waterproof Membrane Welding Machine Free Shipping

　　The principle of the protective measures adopted by the specially developed climbing welding machine for leakage is that the climbing welding machine can be used normally without water. If water appears on the ground during the use of the climbing welding machine, it will trip as soon as it is used. Through the tripping protection, it tells everyone that there is leakage in the shell of the climbing welding machine equipment. If you want to solve this problem, just place a board at the bottom of the climbing welding machine mechanical equipment to use it normally. If there is a leakage in the climbing welding machine and the method of raising it does not work, and the fault phenomenon is different from the above, it is highly likely that the internal parts of the climbing welding machine have been damaged.

　　What are the positioning advantages of climbing welding machines? Wipe the vertical welding position clean, paying attention to grease, positioning welding flux slag, and water. To know the size of the weld fillet to be welded, first burn a standard weld fillet according to the size of the weld fillet. High quality welding must be done from bottom to top. Start the arc with the standard welding angle on one side. When swinging the welding wire left and right, be careful not to exceed the range of the molten pool formed by the full dissolution of the welding wire. When swinging left and right, pause on both sides for a while. The length of time depends on the welding angle. If the welding angle requirement is too large, it is recommended to weld multiple times. Generally, it is better to weld under small points. If it is too large at once, it is easy to have insufficient thickness, unsightly appearance, and bulging on both sides. When swinging left and right, be sure to control the rhythm and slowly weld upwards. There are many methods to pass through the positioning point: here we mainly explain two: one is the direct transition method, which requires a high level of personal mastery ability. When welding to the positioning point, swing it directly upwards and burn it. Be careful not to stop in the middle and transition naturally. The duration of stay on both sides depends on personal mastery. Attention should be paid to wearing protective clothing as the transition is fast and the positioning point cannot be fully dissolved, making it easy to explode and weld. The second is the spot welding transition method. When welding to the positioning point, stop and swing left and right twice as a round trip. The spot welding transition continues until the positioning point is reached, and then continue welding. At the end of welding, if there is a molten pool, it must be filled with spot welding. If it is arc climbing welding and vertical welding, and the welding angle is required to be very small, it can be lifted directly without swinging, which requires a bit high technical requirements.

AfterSalesService :

• Geomembrane hot melt welding machine