250 I-beam bending machine, precision and constant horizontal steel bending machine manufacturer

Description :

　　250 I-beam bending machine, precision and constant horizontal steel bending machine manufacturer

　　Bending machines are now widely available in the market, capable of completing bending tasks for various types of steel such as channel steel, track steel, and round steel pipes. Different types of steel arches and arches with different angles require different grinding tools. The recognition of the bending machine in the market is very high now. Greatly improving the construction speed of profiles and saving labor for workers.

　　Hydraulic I-beam bending machine

　　Electric motors are used to drive the operation of hydraulic pumps, with one group using pistons and the other group using hydraulic pumps to drive the rotation of bending work plates. Of course, after the bending process is completed, attention should also be paid to the cutting mechanism of the device. The force of the spring is used to separate the center valve from the hydraulic pump, and high-pressure oil also flows back into the mailbox.

　　The I-beam bending machine should be installed at the edge of the workbench, and the rotating handle should extend outside the workbench. The installation screws are three M8 screws. There is a Φ 10 hole on the bottom plate of the two clips, which should also be drilled. Create holes to allow wires to freely pass through them. Straighten the metal wire to be inspected with a length of 200-250mm, and do not damage the surface of the wire during the straightening process. Based on the diameter of the wire in the parameter table, select the radius r of the clamp, the distance b from the top of the clamp arc to the bottom of the rod, and the hole Φ of the rod. The arc radius will be printed on each clip for selection. B is obtained by adjusting the position of the lever through the three holes on the rocker arm. In the following text, manufacturers of precision horizontal steel bending machines with 35, 50, and 75 pole holes of Φ 250 can be distinguished based on the numbers printed around the holes in the pole.

　　The operation steps and matters for hydraulic I-beams are as follows:

　　1. Place the steel that needs to be bent on the control panel, turn on the control box, circuit breaker, and air switch power supply. Never operate the switch with wet hands to avoid the risk of electric shock.

　　2. Check for any abnormal conditions around the control panel, turn the emergency stop switch to the right, and press the hydraulic pump start button. If it cannot be started, it is necessary to notify the electrician or maintenance worker for inspection and repair, and unauthorized repairs are not allowed.

　　3. Operate the button switch to move the hydraulic push rod forward counterclockwise and backward clockwise. Only single person operation is allowed, and there must be no one around the control panel when the push rod is in motion. Observe the working situation and immediately stop the operation if any abnormalities are found.

　　4. After completing the cold bending, return the hydraulic push rod to its original position, press the emergency stop button, and remove the bent part from the control panel. After the operation is completed, press the emergency stop button on the operation box to clamp the workpiece for a new round of operation. If the operation is not continued and the equipment needs to be cleaned, press the emergency stop button on the operation box and disconnect the power supply inside the control box. The manufacturer of the 250 I-beam arch bending machine and the precision horizontal section steel bending machine.

AfterSalesService :

• 250 I-beam bending machine