Siemens S120 single motor module 6SL3320-1TG35-8AA3 340-480V 560A servo drive

Description :

  6SL3320-1TG35-8AA3 is a single motor module of Siemens SINAMICS S120 series, mainly used to solve power output problems in high-precision servo control scenarios. This module is suitable for industrial conditions that require high dynamic response and precise position control, such as large CNC machine tools, packaging machinery, and printing equipment. As the core power component of the S120 drive system, it is connected to the control unit through a DC bus to achieve vector control of the AC motor. Typical operating conditions include heavy load start-up, rapid acceleration and deceleration, and continuous high load operation, which can meet the strict stability and efficiency requirements of modern automated production lines and are key components for building high-performance servo drive systems.

  The rated input voltage range of this single motor module is 380V to 480V three-phase AC, with a rated output current of 560A and high power density. Its protection level is usually IP20, suitable for installation in electrical cabinets, with a working temperature range generally between 0 ℃ and 40 ℃, allowing short-term overload capacity up to 1.5 times the rated current for 60 seconds. The product complies with international standards such as IEC 61800-5-1 and has passed CE certification to ensure compatibility in complex electromagnetic environments. The module adopts modular design and supports book type installation structure, which facilitates the unified planning of heat dissipation ducts. Internally integrated temperature monitoring and electronic protection functions provide real-time feedback on operating status, ensuring safe operation of equipment under extreme working conditions and complying with general electrical specifications in the field of industrial automation.

  When selecting, it is necessary to clearly distinguish the differences between single motor modules and dual motor modules or power modules. 6SL3320-1TG35-8AA3 is dedicated to driving a single high-power servo motor and is not suitable for direct power supply from the slave shaft in multi axis synchronous control. If the application scenario involves multiple low-power motors, multi axis modules should be considered to save space and cost; If only rectification power supply is required, line reactors or power modules should be selected. This model is suitable for applications that require extremely high dynamic performance, such as high-speed spindle drives. When purchasing, it is necessary to check the matching degree between the motor nameplate parameters and the module rated current to avoid the risk of "big horse pulling small car" or overload. At the same time, it is necessary to confirm the firmware version compatibility of the control unit (CU), ensure consistent communication protocols, and avoid debugging difficulties caused by software version differences.

  When installing the 6SL3320-1TG35-8AA3 single motor module, it is necessary to ensure sufficient upper and lower heat dissipation space. It is recommended to install it vertically to facilitate air convection. When wiring, it is necessary to strictly tighten the power terminal and motor terminal according to the torque requirements to prevent poor contact from causing overheating. In daily maintenance, the air inlet filter should be cleaned regularly to prevent dust accumulation from affecting heat dissipation efficiency. Common faults include overcurrent alarm and over temperature protection. At this time, the insulation resistance of the motor and whether the load is stuck should be checked. After long-term disuse, it is recommended to conduct a no-load test and gradually load it to the rated working condition before restarting. Pay attention to the discharge time of the internal capacitors in the module. After power failure, wait for the indicator light to turn off before performing maintenance operations to ensure personnel safety and extend the service life of the single motor module.

AfterSalesService :