FQ Pneumatic Axial Flow Local Ventilator Parameters

Description :

　　FQNO5.0Parameters of mine pneumatic pressure type axial flow local ventilation fan

　　Parameters of mine pneumatic pressure type axial flow local ventilation fan,FQSeries of Pneumatic Axial Flow Local Ventilators, Shanxi Manufacturer of Axial Flow Local Ventilators

　　More than 100 coal mines in ten major mining areas, including Shenhua Group's FQNO5.0 pneumatic press in axial flow fan, Yanzhou Coal Industry's FQ5.0 pneumatic press in axial flow local fan, Datong Mining and Zao Mining Group's FQNO5.6 pneumatic press in axial flow local fan, have achieved important results.

　　1、 Characteristics and parameters of FQNO3.55 pneumatic press in axial flow local ventilation fan

　　The ventilation fan consists of components such as a guide vane, impeller, pneumatic motor, and casing. The pneumatic motor is installed in the explosion-proof chamber inside the casing, connected to the impeller through a transmission group and drives the impeller to rotate. The airflow enters the rotating impeller from the guide fluid, and the airflow accelerated by the impeller is deflected by the guide vanes, causing the airflow discharged by the fan to rotate and blow away harmful gases such as accumulated gas in the tunnel.

　　2、 Characteristics of FQ2.5 Mine Pneumatic Compression Axial Flow Local Ventilator

　　1. Powered by a pneumatic motor, it is safe and reliable to use in environments with explosive hazards.

　　2. The fan impeller is driven by gas and has superior overload protection function. There will be no dangerous phenomena such as strong friction and rigid damage that may occur with electric motor drive.

　　3、 Structural diagram of FQ2.5 mining pneumatic press in axial flow local ventilation fan

　　4、 Installation of FQNO2.5 Mine Pneumatic Compression Axial Flow Local Ventilator

　　1. The ventilation fan has been debugged and inspected before leaving the factory.

　　2. The ventilation fan must be installed in the main airflow of the corner area or on the fresh air side of the partially ventilated blind alley.

　　3. The distance between the outlet of the ventilation fan and the area or working point where harmful gases accumulate should be greater than 3m to 6m.

　　4. The intake pipe of the ventilation fan is a 13mm high-pressure rubber hose, and the exhaust pipe is a 13mm or 16mm high-pressure rubber hose. The joint type is a quick connector, and the length of the rubber hose is 3m to 5m. The hose must be blown clean before connection, and foreign objects should be avoided from entering or remaining in the hose.

　　Shandong Yucheng Mining Equipment Co., Ltd. is a manufacturer of FQNO3.55 pneumatic pressure type axial flow local ventilation fan. Our company has sold it to more than 100 coal mines in ten major mining areas, including Huayuan Coal Mine, Shenhua Group's FQNO5.0 pneumatic pressure type axial flow ventilation fan, Yanzhou Coal Industry's FQ5.0 pneumatic pressure type axial flow local ventilation fan, Datong Mining and Zao Mining Group's FQNO5.6 pneumatic pressure type axial flow local ventilation fan, Xinwen Mining Group, Yongmei Group, Jiaomei Group, Pingdingshan Coal Industry Mining Group, Jingyuan Coal Industry, etc., and has achieved important results. The sentence is:.

AfterSalesService :

• FQ Pneumatic Axial Flow Fan