Kcs-230D mining wet dust removal fan KCS120 D wet vibrating wire dust removal fan

Description :

　　Kcs-230DMining dust removal fan/KCS120DWet vibrating wire dust removal fan

　　KCS-120LD，KCS-180LD，KCS-120D，KCS-230DMining wet dust removal fanWe strongly recommend Tai'an Yucheng Mining Equipment Co., Ltd. as the manufacturer. The Kcs-230 wet vibrating wire dust removal fan is suitable for dust removal of various mobile or concentrated dust sources underground and on the ground in mines, such as excavation workfaces, overturning areas, belt transfer areas, and anchor spray jet machines in various dust producing workplaces.

　　The KCS-230 mining wet vibrating wire dust removal fan integrates multiple advanced dust removal principles. Compared with other products of the same purpose, the KCS-230 wet vibrating wire dust removal fan has a wide dust removal range. This dust removal fan has good effects on dust particles beyond 0.5 μ m; The dust removal effect does not change with working time; High air volume and low energy consumption.

　　The Kcs-230D mining dust removal fan is developed based on the summary of the structure and technical performance of existing wet dust removal fans in China, and a new generation of widely used energy-saving dust removal ventilation fan is designed and produced for various mobile and centralized dust sources underground and on the ground in mines.

　　Working principle of Kcs-230 wet dust removal fan:

　　Figure 1: Schematic diagram of dust removal fan structure for KCS-120 (230) D series tunneling machine

　　Kcs-230 mine wet vibrating wire dedusting fan fully mixes dust gas with humidified spray water. Dust particles of various sizes form large particles after moisture absorption and high-speed collision, and enter the cyclone density separation device at the set tangential speed; In the cyclone density separation device, the high-speed rotating three-phase mixed gas of gas, water, and mud is stratified according to particle size and density in the centrifugal force field. The water droplets of mud and large particles are accelerated and adsorbed onto the cylinder wall before being discharged. The clean air with small water droplets is discharged after further water gas separation, thus achieving air purification effect.

　　Mining KCS-230 mining wet vibrating wire dust removal fan parameters:

　　1. Rated processing air volume: 230m3/min

　　2. Total dust removal efficiency: ≥ 99%

　　3. Respiratory dust removal efficiency: (90-98)% (positively correlated with filtration wind speed)

　　4. Design work resistance: ≤ 1200Pa

　　5. Liquid to gas ratio: (0.03-0.09) L/m3 (processing air volume) (depending on the dust concentration in the air)

　　6. Spray water supply pressure: ≥ 0.3MPa

　　7. Work noise: ≤ 85dB (A)

　　8. Applicable ambient temperature:>0 ℃

　　9. Applicable dust concentration range: (0-24000) mg/m3 (processing air volume)

　　10. Applicable dust types: coal dust, rock dust, cement dust, iron ore dust.

　　11. Explosion proof motor voltage: 50Hz, 380V/660V, 660V/1140V.

　　We strongly recommend Tai'an Yucheng Mining Equipment Co., Ltd. as the manufacturer of KCS-230D mining wet dust removal fan. Tai'an Yucheng takes the safety production of miners as its mission and is committed to researching, producing, and supplying safer mining equipment.

AfterSalesService :

• Kcs230D mining dust removal fan