Sales of SCF-6/KCS230D Mining Wet Dust Removal Fan

Description :

　　SCF-6/KCS230DMining wet dust removal fansales

　　SCF-6/KCS230D mining wet dust removal fan manufacturer sells, and Tai'an Yucheng Mining Equipment Co., Ltd. produces FBD press in ventilation fan, KCS series dust removal fan, FBY ventilation fan, FQC pneumatic extraction fan and other coal mine specific fan series. The products have been widely used in more than 100 coal mines in ten major mining areas, including Shenhua Group, Yanzhou Coal Industry, Datong Mining, Zao Mining Group, Xinwen Mining Group, Yongmei Group, Jiao Coal Group, Pingdingshan Coal Industry Mining Group, Jingyuan Coal Industry, etc., and have achieved important results.

　　Working principle of SCF-6/KCS230D mining wet vibrating wire dust removal fan:

　　The SCF-6/KCS230D wet vibrating wire dedusting fan fully mixes the dust gas with the humidified spray water, and the dust particles of various sizes form large particles of mud after moisture absorption and high-speed collision. The SCF-6 wet vibrating wire dedusting fan enters the cyclone density separation device at the set tangential speed; The SCF-6 wet vibrating wire dust removal fan is used in the cyclone density separation device. The high-speed rotating three-phase mixed gas of gas, water, and mud is stratified according to particle size and density in the centrifugal force field. The water droplets of mud and large particles are accelerated and adsorbed onto the cylinder wall before being discharged. The dry clean air with small water droplets is discharged after water gas separation, thus achieving air purification effect. As shown in the following figure:

　　1. Extract type axial explosion-proof bureau ventilation fan 2, frame 3, dust collector

　　Figure 1: Schematic diagram of dust removal fan structure for KCS-120 (230) D series tunneling machine

　　1. Pull out axial explosion-proof local ventilation fan 2, frame 3, dust collector

　　Figure 2: Schematic diagram of dust removal fan structure for KCS-410D series tunneling machine

　　The SCF-6/KCS230D mining wet vibrating wire dust removal fan integrates multiple advanced dust removal principles. Compared with other products of the same purpose, this dust removal fan has a large dust removal range and has good effects on dust particles beyond 0.5 μ m; KCS230D wet vibrating wire dust removal fan has high dust removal efficiency, stable performance, and the dust removal effect does not change with working time; The SCF-6/KCS230D wet vibrating wire dust removal fan has a large processing air volume and low energy consumption, and the energy consumption of the dust removal fan is less than one-third of other products with the same purpose; Compact structure, small size, lightweight structure, convenient for use in underground mobile environments; During operation, there is no maintenance required, no consumables, and low operating costs.

　　Performance and main technical parameters:

　　1. Total dust removal efficiency: ≥ 97%

　　2. Liquid ratio: ≤ 0.4L/m3.

　　3. Processing air volume m3/s: series models.

　　4. Applicable dust concentration range: C ≤ 24000mg/m3 processing air volume.

　　5. Working mode: Continuous work.

　　6. Applicable ambient temperature: 0 ℃~40 ℃.

　　7. Applicable dust types: hydrophilic dust such as coal, rock, cement, etc.

　　8. Explosion proof motor voltage: 380V/660V or 660V/1140V (specified when ordering).

　　The SCF-6 mining wet dust removal fan from Shandong Yuzheng is excellent. SCF-6 mining wet vibrating wire dust removal fan to Tai'an Yucheng Mining Equipment Co., Ltd.

AfterSalesService :

• KCS mining wet dust removal fan