Yucheng brand DZG23 electric drilling machine 50kg rail railway electric drilling machine

Description :

　　Yucheng brand DZG23 electric drilling machine 50kg rail railway electric drilling machine

　　DZG23Rail drilling machine, DZG electric rail drilling machine Yucheng brand, DZG31 electric rail drilling machine, 60kg rail electric drilling machine manufacturer

　　The railway rail drilling machine with a weight of 43-75kg/m is selected from Tai'an Yucheng brand. The railway rail drilling machines produced by Tai'an Yucheng Mining Equipment Co., Ltd. can be divided into internal combustion rail drilling machines, hydraulic rail extruders, and the electric rail drilling machine we are talking about today. The models are divided into three types: DZG13, DZG23, and DZG31. The internal combustion type and electric type are suitable for drilling operations on heavy-duty rails and various types of rails with a weight of 43-75kg/m.

　　1、 Function of DZG-23 electric rail drilling machine:

　　It is suitable for railway laying, line maintenance and repair, especially for drilling operations in sections and sections with power and electricity.

　　2、 Technical parameters of DZG-23 electric rail drilling machine:

　　1. Drilling range: ? 32mm

　　2. Power is 1000W3. Spindle speed is 270-300r/min

　　4. The installation time is 20-30 seconds. The unloading time is 15-20 seconds. The drilling time is 1.5-2 minutes, and the continuous drilling time for three holes is 6-8 minutes

　　6. The travel distance shall not be less than 105mm

　　7. Aperture deviation ± 0.5

　　8. Aperture roughness of 12.5 or above

　　9. The distance error between the hole and the rail end surface is ± 0.5mm, the error between the three holes is ± 0.75mm, and the distance error between the three holes and the bottom surface is ± 0.75mm

　　10. Dimensions: 600mm x 230mm x 260mm

　　12. Hollow drill bit

　　13. Suitable for 50-60kg rails, especially for 60kg/m rails

　　3、 Operating Procedures for DZG-23 Electric Drilling Machine:

　　Before use:

　　1.1 First, check if there is any skin damage or leakage in the power cord of the motor. Connect the power supply to the motor and observe if it runs normally without load for half a minute.

　　1.2 Select the same positioning block as the drilled rail type and install it on the opposite part of the drilling machine fixture.

　　1.3 Rotate the feed handle counterclockwise, first stop the spindle, and then install the hollow drill bit into the front end of the spindle.

　　2. In homework:

　　2.1 Place the fixture on the top surface of the track, adjust the appropriate length of the top thread, and press down on the fixture handle to lock it. If the locking strength is not sufficient, turn the top screw handle clockwise until it is locked.

　　2.2 Connect the power supply to the motor, idle for 30 seconds, and when the motor runs smoothly without any abnormalities, rotate the handle clockwise. When the drill bit enters the turning state, inject water for cooling. To prevent the drill bit from burning the orchid.

　　2.3 After drilling, stop injecting water, quickly turn the handle counterclockwise to stop the spindle, and then turn off the motor. Lift the card and press the handle, detach the whole machine from the track, and complete the operation.

　　The DZG-23 electric rail drilling machine is our company's flagship product, widely used, economical and practical. It is an excellent choice for you. If you have any other questions, please contact our business manager. Yucheng is dedicated to serving you.

AfterSalesService :

• DZG23 electric drilling machine