Mining gas hand-held drilling rig ZQS-35/1.6S available for sale in stock

Description :

　　Mining gas hand-held drilling rigZQS-35/1.6Ssell

　　Pneumatic handheld drilling rig,ZQS-35/1.6SDrilling rig,ZQS-35/1.6SHandheld drilling rig for sale, mining wind coal drill model

　　The pneumatic hand-held drilling rig produced by Tai'an Yucheng Mining Equipment Co., Ltd. has been widely used in major coal mines, such as Shenhua Group, Yanzhou Coal Industry, Datong Mining, Zaokuang Group, Xinwen Mining Group, Yongmei Group, Coking Coal Group, Pingdingshan Coal Mining Group, Jingyuan Coal Industry, etc., and has received good feedback. Thank you for choosing Yucheng, our products and complete after-sales service will meet your satisfaction. Let's learn about the ZQS-35/1.6S pneumatic handheld drilling rig together.

　　1、 Working principle of ZQS-35/1.6S pneumatic handheld drilling rig:

　　1. Compressed air enters the anchor drilling rig through a filter, oil injector, and filter screen

　　2. Open the motor control valve, compressed air drives the gear motor, and through gear reduction, drives the spindle to rotate clockwise, adjusting the working state of the handle control motor.

　　3. Open the water valve during wet drilling, and the flushing water will enter the drill rod through the filter screen, water pipe, and spindle inner hole to flush the borehole. Adjust the opening amount of the water valve to adjust the water volume.

　　2、 Precautions for using ZQS-35/1.6S pneumatic handheld drilling rig:

　　Before drilling, it is necessary to ensure the stability of the roof and coal support for safe operations.

　　2. When drilling, it is forbidden to hold the drill rod with your hands.

　　When opening the eyes, stabilize the drilling rig and perform the eye opening operation.

　　4. When drilling, the manual thrust should be increased uniformly to avoid accidents such as slow drilling speed, stuck drill, broken drill rod, bent drill rod, and broken drill bit edge caused by uneven manual thrust.

　　5. When loading and unloading the drilling rig, there will be a reverse torque. But both can hold the handle and achieve balance. It is strictly prohibited to load suddenly. During loading, the operator should pay more attention to their position and shake hands reasonably.

　　6. Place the drilling rig vertically in a safe location to prevent accidental damage such as blasting, rolling, rolling, and collision.

　　3、 Characteristics of ZQS-35/1.6S pneumatic handheld drilling rig:

　　The ZQS-35/1.6S pneumatic handheld drilling rig has the characteristics of safety and explosion prevention, high torque, high speed, small mass, small volume, high efficiency, simple structure, high handle strength, not easy to damage, and convenient maintenance. After on-site promotion and use, it was concluded that the drilling rig has high work efficiency, good support quality, and low labor intensity. At the same time, the occurrence of coal mine accidents has been reduced, and the safety of workers has been effectively guaranteed.

　　Tai'an Yucheng specializes in various types of mining drilling rigs, including the ZQS series pneumatic handheld drilling rig, MQT pneumatic anchor drilling rig, MYS hydraulic handheld anchor drilling rig, ZM15T explosion-proof handheld coal drill, KHYD series coal mine rock drill, FQZ concrete coring drilling rig, ZDJ series pit drilling rig, etc. There are many types and models available for purchase.

AfterSalesService :

• Mining gas hand-held drilling rig