Multi purpose rock drill KHYD140 mining rock drill accessories wholesale

Description :

　　Multi purpose rock drillKHYD140Wholesale of mining rock drill accessories

　　KHYD140Mining rock drill, multi-purpose rock drill, wholesale of rock drill accessories,KHYD140Rock drill production

　　The KHYD140 rock drill is one of our company's outstanding products in terms of market sales, mainly because this series of products can not only be used for drilling water, gas detection, and drainage holes in coal mines, but also for construction and road construction, as well as environmental protection decoration construction. The following mainly introduces this drilling rig.

　　1、 The role of KHYD140 rock drill

　　1. Application in coal mines: The KHYD140 rock drill is mainly suitable for gas emission drilling, blasting coal drop holes, and rock drilling in the mining face to explore and prevent coal and gas outbursts. It can also be used to drill water holes in small alleyway sections.

　　2. Application of rock drill in construction and road construction: KHYD140 rock drill is mainly used for drilling pipes or earthwork excavation holes with a tilt angle of less than 50 ° and a diameter of less than 200mm in construction or road construction. The motor can be non explosion proof.

　　3. Application of KHYD140 rock drill in environmental decoration: KHYD140 rock drill is mainly used for drilling holes in walls, which was once implemented by a customer. The drilling depth during use was 2.4cm/min, so it can be seen that the application of rock drill is extremely broad. As long as its content can meet your requirements for drilling aperture, drilling depth, and drilling angle, it can be used for you!

　　2、 KHYD140 Rock Drill Parameter Table:

　　3、 Instructions and precautions for using KHYD140 rock drill:

　　1. Determine the installation position of the drill frame (self-made) based on the usage scenario and drilling location

　　2. First, install the chain on the host, then install the host on the runway, connect both ends of the chain to the runway, and adjust the chain rod to obtain a certain tension for the chain. Finally, fix the runway to the drilling rig.

　　When drilling rock holes, the water flow rate is 5-8L/min and the pressure is 0.3-0.5Mpa

　　4. Rigorously drill holes (excluding when using spiral blade drill rods), strictly follow the method of supplying water first, then starting drilling, and stopping drilling first and then stopping water. During drilling, attention should be paid to the water supply situation. In case of sudden water stoppage, drilling must be stopped immediately to allow the drill bit to leave the bottom of the hole in a timely manner, in order to prevent accidents such as drill bit betting and jamming.

　　5. In the junction box components, galvanized washers on the wiring terminals are not allowed to be used with large diameters to ensure creepage distance and electrical clearance.

　　If there is any abnormal sound from the rock drill, it should be checked and repaired immediately. The gearbox should be cleaned regularly and the lubricating oil should be replaced. If necessary, the motor should be dried regularly.

　　The mining KHYD140 rock drill (referred to as rock drill) complies with the MT52-1996 coal mine rock drill industry standard and meets the relevant regulations for the manufacturing of explosion-proof electrical equipment for mining. It has the characteristics of reasonable structure, easy mobility, easy operation, safety and reliability.

AfterSalesService :

• KHYD140 mining rock electric drill