Shandong Yucheng and intrinsically safe mining explosion-proof water dispenser

Description :

　　Shandong Yucheng Mining Explosion proof Drinking Water Dispenser Explosion proof and Intrinsic Safety Type

　　Mining explosion-proof and intrinsic safety explosion-proof water dispenser, explosion-proof water dispenser for coal mines, explosion-proof and intrinsic safety water dispenser, mining explosion-proof water dispenser manufacturer, explosion-proof water dispenser direct supply

　　Mining explosion-proof and intrinsic safety explosion-proof water dispenserTaian Yu becomes your provider. We are a manufacturer and our products are directly supplied by the manufacturer. The factory ships them directly, saving you the price difference between intermediaries. We offer you the price, allowing you to buy good products at a low price.

　　1、 Mining explosion-proof and intrinsic safety explosion-proof water dispenserUsage environment:

　　1. The altitude does not exceed 2000m;

　　2. Environmental atmospheric pressure of 80~110kPa;

　　3. Environmental temperature of 5-40 ° C;

　　4. The relative humidity of the surrounding air should not exceed 95% (at 25 ° C);

　　5. Non mining working faces in coal mines with methane mixtures and coal dust explosion hazards;

　　6. In areas without significant vibration;

　　7. In an environment without damaging metal insulation with gases and vapors.

　　2、 Mining explosion-proof and intrinsic safety explosion-proof water dispenserUsage: (When using this product for the first time, it must be filled with water and then powered on.)

　　1. Connect the tap water pipe to the 4-point connector above the water dispenser until water flows out of the hot water valve before power can be supplied. When the water is full, automatically stop adding water (rinse several times for repeated use).

　　2. After filling up with water, connect the power cord to a three-phase 127V power supply and ground the casing.

　　3. Turn on the power switch for heating, and the red heating indicator light will turn on. When the water temperature reaches 85 ℃. The red indicator turns off and the green indicator light turns on. Stop heating and enter the insulation state. When the water temperature is below 75 ℃, heat again. At this time, the red light turns on and the green light turns off.

　　3、 Mining explosion-proof and intrinsic safety explosion-proof water dispenserInstallation and maintenance:

　　1. There are two temperature controllers, 85 ℃ and 95 ℃, inside this heater. If the 85 ℃ temperature controller malfunctions, when the water temperature exceeds 95 ℃, the 95 ℃ temperature controller will stop heating. At this time, the red and green lights will turn off and the buzzer will sound an alarm, indicating that the 85 ℃ temperature controller is damaged and should be replaced.

　　2. It is strictly prohibited to add electricity when there is no water, and it is forbidden to burn it empty.

　　3. During use and maintenance Do not change the parameters of components related to intrinsic safety and intrinsic safety circuits Specification and model.

　　4. This product must be used in conjunction with a comprehensive lighting protection device.

　　5. During maintenance and repair, it is strictly prohibited to open the cover with power on! It is strictly prohibited to damage the explosion-proof surface!

　　6. It is not allowed to use cable grounding core wires as intrinsic safety control circuits.

　　When not in use, this product should be stored in a ventilated, dry, and non corrosive gas environment.

　　The models of Tai'an Yucheng Mining Explosion proof and Intrinsic Safety Explosion proof Water Dispenser include YBHZD5-1.5/127, YBHZD5-1.8/127, YBHZD8-3/127F, YBHZD-3/127F, etc., with a complete range of models. If you need it, please feel free to call and place an order.

AfterSalesService :

• Mining explosion-proof water dispenser