Customized belt middle sampling machine coal conveyor belt sampling device

Description :

　　Customized belt middle sampling machine Coal conveyor belt sampling device

　　Belt middle sampler, belt middle sampler, coal conveyor belt sampling device, parameters of belt middle sampler

　　1、 Parameter table of sampling machine in the middle of the belt:

　　2、 Installation position diagram of the sampling machine in the middle of the belt:

　　3、 Structural description of the sampling machine in the middle of the belt

　　The sampling device in the middle of the coal conveyor belt mainly consists of a brake motor reducer 1, a coupling 2, a sampling head 3, two proximity switches 4, a steel structure support cabinet frame 5, an outer cover 6, etc.

　　4、 Characteristics of the belt middle sampling machine:

　　1. A set of flexible arc-shaped roller sets are installed on the feed side and discharge side of the sampling machine. Through this arc-shaped roller set, the main adhesive tape of the sampled section is shaped, so that the adhesive tape in the sampling area forms a circular arc consistent with the running trajectory of the sampling bucket. When the motor drives the sampling head, the sampling head can quickly cut the entire longitudinal width of the section to complete the sampling. Completely overcome the phenomenon of missed sampling caused by the adhesive tape resting angle. At the same time, it also plays a role in stabilizing the tape, eliminating phenomena such as coal scattering and deviation caused by the tape swaying during sampling.

　　2. The sampling bucket head of the belt middle sampling machine is equipped with a polyurethane plate, ensuring that the entire cross-section of the coal flow can be scraped completely without damaging the belt

　　3. The sampling bucket is made of stainless steel for easy replacement and features rounded corners to ensure no material accumulation inside; The sampling machine frame (spanning the main belt) is equipped with skirts on both sides to ensure that no material is scattered during scraping;

　　4. The sampling bucket is driven by an AC motor and has a manual release function. If the sampling bucket is stuck in the middle of the belt conveyor due to a fault, it can be manually lifted; The proximity switch also has zero speed detection function. If the switch signal is not received within a certain period of time, an alarm signal will be issued.

　　Maintenance and upkeep of the sampling device in the middle of the coal conveyor belt

　　1. Regularly inspect the bearing seat and the fixing bolts of the reducer for looseness, and promptly handle any abnormalities found.

　　2. Check the wear of the rubber baffle and scraper, and adjust or replace them in a timely manner.

　　3. Regularly check the bearings and gearbox for oil shortage, and promptly replenish or add lubricating oil.

　　Please call me for specific prices.

AfterSalesService :

• Belt middle sampling machine