MLC5-9 mining material truck with large capacity and 5-ton material truck for coal mines

Description :

　　MLC5-9Mining material transport vehicles have a large capacity coal minefiveTon material truck

　　MLC5-9Mining material truckMLC5-9Mining material trucks,fiveTon material truck

　　MLC5-9 Mining Material Transport Vehicle Parameters:

　　Vehicle capacity: 5m3

　　Load capacity: 5T

　　Track gauge: 900mm

　　Wheelbase: 1100mm

　　Wheel diameter: 350mm

　　Traction height: 320mm

　　Dimensions: 3450 * 1320 * 1300mm.

　　MLC5-9 mining material transport vehicle model number:

　　M - represents coal mine vehicles

　　L - represents material

　　C - represents coal mine vehicles

　　5- represents the load capacity of the mining truck in tons

　　9- indicates a track gauge of 900mm.

　　Precautions for Operation and Maintenance of MLC5-9 Mining Material Transport Vehicle:

　　MLC5-9 mining material transport vehicle is the main transportation and safety equipment for roadway and working face transportation. During operation, the wheels, buffer springs, single ring chains, three ring chains, pin shafts, and contact cores should be kept in good condition, and the protective devices should be kept in good condition.

　　During the daily operation and maintenance of the MLC5-9 mining material transport vehicle, the following main points should be noted:

　　1. The wear of the pin shaft of the chain link that bears traction force shall not exceed 15% of the original size, and the bending value of the chain link pin shall not exceed 10% of the diameter.

　　2. The cast steel joint shall not have cracks, and the buffer spring shall not break or deform.

　　3. The material vehicle should run smoothly, and the diameter difference between the two wheel treads of the same wheel set should not exceed 2 mm. When one of the four main wheels of the same material vehicle does not touch the track surface on a flat track, the gap should not exceed 2 mm. Otherwise, it will immediately stop running for repair or adjustment.

　　4. The wheels shall not have cracks, and the residual thickness of the wheel rim wear shall not be less than 13 mm, and the residual thickness of the tread shall not be less than 7 mm

　　5. The wheels should be oiled every two weeks, and when oiling, the new oil must push out the old oil.

　　6. The steering device should be flexible and reliable, and should rotate flexibly in both horizontal and vertical directions.

　　To pursue a dream, turn all your efforts into a horizon to meet it; To pursue success, turn the power of confidence into scenery to showcase it. Tai'an Yucheng turns customer trust into our continuous driving force, striving for the optimization of product quality.

AfterSalesService :

• Mining material transport vehicle