Guigang supplies inclinometers, factory prices, and usage instructions for inclinometers

Description :

　　Firstly, an introduction to the method of burying inclined pipes. The method of measuring inclined pipes is to use the method of bundling and burying, only in this way can the inclined data be measured more accurately. The specific method is generally to tie the inclinometer tool to a cage of a steel structure, and then the rigid structure cage will be placed into a hole or groove according to the construction requirements, and cement will be filled inside.

　　Next is how to choose the position of the inclinometer tube. According to the current general position selection, the bottom of the inclined tube should generally reach the bottom of the metal cage structure or be slightly higher, so that the top can be flexibly adjusted, while the top must protrude. There is also a strict requirement for the distance between the inclined tube and the metal cage structure, which should not exceed 1.2 meters in general, otherwise there may be inaccurate measurement problems.

　　The third one is about the requirements for inclinometers. After burying the inclined pipe and placing it in the right position, there are some special requirements, such as the pipe should be tightly sealed, there should be no damage in the middle of the pipe, and the pipe should be kept clean. In addition, it is necessary to ensure the normal existence of the inclined tube during monitoring and not to unbind it at any time.

　　The method, location, and requirements for burying inclinometers in foundation pit engineering monitoring mainly include these aspects. The inclinometer pipe is a business that is prone to problems on small joints, and many experienced workers have been working on it for several years and still encounter problems. So you must be careful and meticulous to ensure that the task is completed relatively well. The inclinometer tube and steel cage should be tied and buried, with a binding distance of no more than 1.5 meters. The fixing of the inclinometer tube and steel cage must be very stable to prevent them from falling off during concrete pouring. At the same time, attention must be paid to the longitudinal torsion of the inclinometer tube, as a small torsion angle may cause the inclinometer to get stuck in the guide groove. The bottom of the pipe should be level with or slightly lower than the bottom of the steel cage, and the top should reach the ground or the top of the guide wall. Protect the top with a 1.2-meter-long iron sheet or pipe sleeve to prevent damage during concrete chiseling

AfterSalesService :

• Guigang supplies inclinometers