Shaoxing inclinometer pipe dealers nationwide receive real-time quotes for orders

Description :

　　When burying inclinometers, they should be kept vertical to prevent floating, breaking, and twisting; The direction of a pair of guide grooves in the inclinometer tube should be consistent with the displacement direction to be measured.

　　(5) When using the drilling method for burial, the pores between the inclinometer tube and the borehole should be filled tightly.

　　(6) Before using the inclinometer tube, rinse it thoroughly with clean water.

　　(7) When using the bottom as the starting point, the burial depth of the pipe bottom should be at the bedrock or at a sufficient depth into the foundation pit bottom (normally not less than 5 meters deep into the foundation pit bottom).

　　(8) When using the upper pipe mouth as the starting point for deep horizontal displacement, the change in pipe mouth coordinates should be measured and corrected for each monitoring.

　　At present, the binding of the inclinometer tube is mainly achieved by connecting the inclinometer tube with the steel cage through iron wire or binding wire to achieve the purpose of embedding the inclinometer tube. Due to the direct contact between the inclinometer tube and the steel reinforcement during binding, the contact surface is uneven, resulting in low smoothness of the inclinometer tube and affecting the accuracy of monitoring data. In severe cases, the inclinometer tube cannot be used.

　　Technical implementation elements:

　　：

　　In order to overcome the above-mentioned shortcomings, the present invention provides a method for burying a inclinometer tube, which connects the inclinometer tube to a steel cage by installing a fixing device on the inclinometer tube, achieving the purpose of fixing the inclinometer tube and ensuring smooth binding of the inclinometer tube.

　　The technical solution adopted by the present invention to solve its technical problem is:

　　A method for burying inclinometers, comprising the following steps:

　　a、 Connect the inclinometers in sections of 2m or 4m through joint pipes, and fix the joint pipes and inclinometers with four self powered screws to connect the inclinometers to the required length;

　　b、 Install fixing devices every 1.5-2 meters on the inclinometer tube connected in step a, the fixing devices comprising an upper half buckle bowl and a lower half buckle bowl, both of which are equipped with two steel wire rope storage containers on the outer side, and the steel wire rope is installed inside the steel wire rope storage container;

　　c、 Fix the inclinometer tube to the steel cage using the steel wire rope in the steel wire rope storage device, and then adjust the position of the inclinometer tube before fixing the steel wire rope;

　　d、 Repeat steps b and c to fully secure the entire inclinometer tube.

　　The length of the steel wire rope is 1 meter.

AfterSalesService :

• Shaoxing inclinometer tube