Mud pump accessories, seals, cups, water seals, pull rods, oil seals, back covers, gaskets, mudguards, industrial grade wear-resistant

Description :

  Mud pump accessories are key components for maintaining pump body pressure and fluid transport efficiency in oil drilling and mining washing operations. This kit mainly solves the problems of medium leakage, piston rod wear, and sediment intrusion under high-pressure reciprocating motion. Typical working conditions include high sand content mud environments and continuous high-intensity operation scenarios. The core components include cups, water seals, rod oil seals, etc., which directly determine the volumetric efficiency and operational stability of the mud pump. They are suitable for maintenance and replacement of various three cylinder single acting or five cylinder double acting mud pumps, ensuring that the equipment maintains sealing performance under harsh working conditions.

  This series of mud pump accessories covers key parts such as cups, water seals, rod oil seals, rear cover pads, and mudguards. Leather bowls are usually made of oil resistant and wear-resistant rubber or polyurethane materials, which have high resilience and tear resistance; The pull rod oil seal is designed with a multi lip structure, effectively blocking sediment from entering the crankcase; The back cover pad is made of high-temperature and high-pressure resistant composite material to ensure that there is no leakage on the joint surface. The execution standard refers to API Spec 7K or relevant industry specifications, with strict control of dimensional tolerances to ensure the accuracy of fit with mainstream brand mud pump piston rods and cylinder liners. It is suitable for temperature ranges typically between -20 ℃ and 120 ℃, meeting the needs of most field operations.

When selecting, it is necessary to clarify the specific model, cylinder liner diameter, and piston rod size of the mud pump. There may be differences in the interface of different brands of accessories. The material of the leather bowl should be selected based on the mud density and abrasion resistance. For high abrasion conditions, it is recommended to use reinforced polyurethane material; If the medium contains chemical corrosive additives, the chemical resistance of the rubber material needs to be confirmed. This kit is not suitable for non reciprocating centrifugal pumps or screw pumps. Compared with universal seals, specialized mud pump accessories have been optimized in terms of compressive strength and resistance to sediment erosion. When purchasing, it is necessary to check the original factory drawings or physical samples to avoid installation failure or early failure due to dimensional deviations.

  Before installing the mud pump accessories, it is necessary to thoroughly clean the piston rod and the inner wall of the cylinder body, and check whether there are scratches or rust on the surface to avoid damaging the new sealing parts. When installing the leather bowl, a dedicated guide sleeve should be used to avoid flipping or trimming; Pay attention to the lip direction of the pull rod oil seal to ensure it is facing towards the pressure side. During daily maintenance, regular checks should be conducted for leaks. If dripping worsens, it should be replaced in a timely manner to prevent sediment from entering the bearing position and causing greater damage. Common faults include premature wear of the cup and oil seal flanging, which are often caused by poor lubrication or misalignment. It is recommended to replace them in a complete set according to the overhaul cycle to restore pump efficiency and extend the service life of the entire machine.

AfterSalesService :