Erdos settlement plate agent can customize the size according to customer requirements and make samples

Description :

　　The size of the Ordos settlement plate agent can be customized according to customer requirements and can be used as a sample

　　The production and use of settlement plates: 1. The settlement plate is composed of steel plates, measuring rods, and protective sleeves. The size of the base plate is 400cm × 400cm × 10cm, and the measuring rod is made of Φ 40mm steel pipe, fixed in a vertical position with the base plate. The protective sleeve is made of plastic sleeve, and the sleeve size is suitable to cover the measuring rod and allow the ruler to enter the measuring head. As the filling height increases, the measuring rod and sleeve are also correspondingly raised, with each section not exceeding 55cm in length. After raising, the top surface of the measuring rod should be slightly higher than the upper opening of the sleeve. When not measuring, seal the upper opening of the casing with a cap to prevent the filler from falling into the pipe and affecting the sinking of the measuring rod. Before installation, the roadbed surface must be compacted, and the installation position must be measured. Once the position is fixed, the bottom elevation of the slab should be measured immediately, and this value should be recorded as the initial value. After filling the height beyond 20cm of the observation rod mouth, compact the entire section, and then extend the measuring rod and protective sleeve of the settlement plate. The extension method can be threaded connection or welding connection (measuring rod welding, protective sleeve connection with adhesive tape). After connection, immediately measure the elevation and calculate the actual connection length.

AfterSalesService :

• Ordos subsidence plate